User manual PENTAX AF100P FLASH

[. . . ] The batteries should be inserted with "+" and "-" side facing correctly. Remove the batteries from the grip immediately if they become hot or begin to smoke. The camera's soft case cannot be used when the battery grip is attached. [. . . ] The camera's soft case cannot be used when the battery grip is attached. Shutter release button Attachment screw Contact pin Av dial 1 Open the battery cover by pulling down the battery cover unlock lever as shown above. 2 Pull out the battery holder from the battery grip, insert the batteries correctly with 3 Slide the battery holder into the battery grip, and close the battery cover as shown above. Refer to page 14 for the number of captures and playback time with a new set of batteries. Use batteries of the same manufacturer and of the same type when replacing the batteries. Make sure the camera and the battery grip are turned off before attaching. The Shutter release button, AE lock button, Tv dial and Av dial on the battery grip are used when taking pictures with the camera in the vertical position as shown below. Please note that nickel hydride batteries have a lower voltage causing other batteries to be consumed first. The camera and battery grip can be used if there is a battery in at least one of them. Carry extra batteries with you when traveling overseas, taking pictures in cold environments or taking a lot of pictures. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]