User manual PEG-PEREGO NAVETTA XL PRIMO

[. . . ] The child’s safety could be put at risk if these instructions are not followed. € Assembly and preparation of the item must be carried out by adults. € Before use make sure that all of the attachment mechanisms are connected properly. € Do not use near heat sources, open flames or dangerous objects that are within reach of the child. [. . . ] When using the product as a carriage, remove the harness and place it in the special pocket. € Only use the product on surfaces that are hard, horizontal and dry. € Take care when adjusting the mechanisms (handle, backrest) with the child present. € Regularly check the handle (or the handles) and the bottom of the carriage to make sure that there are no signs of breakage or damage. € When using the carriage with a stand, check the maximum length of the carriage specified on the stand. Instructions for use using the Navetta XL 1• HOOD: To attach the hood, fasten the clips (fig_a) and then the buttons on the sides (fig_b) and, if present, the back (fig_c). 2• There is a special section in the hood that allows you to see the child from any angle. 4• It is possible to attach the cover to the hood, thus providing the child with greater protection from the elements. Unfasten the cover at the sides (arrow_a), fold it up (arrow_ b) and fasten it to the hood with the Velcro (arrow_c). 6• HANDLE: Rotate the handle upwards until it clicks into place (arrow_a). The handle is only locked in place when it is in the vertical position. To lower the handle, press the two round buttons at the same time (arrow_b) and rotate it downwards (arrow_c). The handle is useful for carrying the Navetta XL (fig_d) and for fitting it to chassis and strollers. 7• ROCKING POSITION: The base of the Navetta XL has a special shape which allows you to rock the child when it is placed on a flat surface. 8• COT POSITION: It is possible to make the Navetta XL into a non-rocking cot by opening out the two legs under the base. 9• ADJUSTING THE BACKREST and THE FOOTREST: with the COMFORT SYSTEM, backrest and footrest can be adjusted simultaneously. Pull the knob outwards (fig_a) while turning it (fig_b) to raise or lower the backrest and the footrest. 1 0• FOUR SEASONS SYSTEM: There are holes under the base of the Navetta XL which can be opened or closed to adjust the air circulation inside it. Ganciomatic system 1 1• Ganciomatic is the quick, practical system that allows you to attach the Navetta XL to the Ganciomatic clips of a stroller or the base of a chassis. To attach the Navetta XL, put it on the stroller or the chassis and press with both hands until it clicks into place. Always apply the brakes on the stroller or chassis before attaching and removing the Navetta XL. € To release it, raise the lever of the Ganciomatic clip (arrow_ a) and lift up the Navetta XL (arrow_b). [. . . ] € Production serial number: on issue of approval, each bassinet unit is given its own unique number. Assistance service • If parts of the product are lost or damaged, replace only with original Peg-Pérego spare parts. For any repairs, replacements, product information, and orders for genuine original replacement parts and accessories, please contact Peg Perego After Sales Service indicating the product serial number, if any. Com • Peg-Pérego may modify the products described in this publication at any time for technical or commercial reasons. [. . . ]