User manual PEAVEY XXL 212

[. . . ] B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. [. . . ] Lead channel activation illuminates the yellow LED, and Clean channel activation illuminates the green LED. CHANNEL This three-position toggle allows selection between the XXL 212 COMBO's three channels. Channel switching can also be accomplished from the included footswitch. see the FOOTSWITCH section of this manual for explanation of switch operation. The CHANNEL switch must be set in the ULTRA position in order for the footswitch to operate properly. The footswitch cable should be connected before the amp is powered up. PREAMP OUT The preamp out can be used to route the amplified signal from the preamp to a mixing console, tape recorder, etc. Connect the preamp output to line-level inputs of other equipment using high quality shielded cable. pOWER AMP IN Used to connect line-level signals to the XXL 212 COMBO's power amplifier section. Connect the power amp input to line-level output of other equipment using high quality shielded cable. This patch disconnects the XXL 212 COMBO preamp section from the power amp section. A higher damping factor (TIGHT) reduces cone vibration more quickly than a lower damping factor (LOOSE). This switch works much like the Resonance and Presence controls found on other Peavey amps, if they were to be turned simultaneously. If the Damping switch is changed, the volume level of the amp will also change and may require re-adjustment of the Master Volume (3). POWER This three-position switch selects the power output level of the power amplifier. Dynamics® control found on other Peavey amplifiers which provides for a more pronounced tube power compression simulation at lower settings. The CABINET IMPEDANCE switch (28) must be set to match the load of the speaker cabinet(s). cABINET IMPEDANCE This three-position switch allows for appropriate selection of speaker cabinet impedance. [. . . ] If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]