User manual PEAVEY XR 800F

[. . . ] Without patching, the XR 800F can be used as a full stereo mixer amplifier (default). In the Main/Monitor mode, one graphic and amplifier can be used for monitor and the other graphic and amplifier for the main L and R (mono) signal. Also included in the master section are 16 stereo digital effects from the award winning DeltafexTM digital signal processor. By including separate time/size and color/tone controls, the user can create many effect settings from the 16 we provided. [. . . ] It is advisable to listen carefully to the output at the same time in order to determine the final setting. If you hear distortion then one or more of the input digital effects level controls are set too high. In Rotary Speaker setting, this adjusts the speed of the speaker rotation. This control allows effects to be heard from the stage via the monitor. When feedback occurs, this system will automatically indicate the graphics slider to use to lessen or eliminate feedback. (NOTE: These LEDs illuminate with any audio signal, not just during feedback. the signal sent to each equalizer is determined by the System Mode Switch (20). SYSTEM MODE SWITCH: This switch is used to configure the XR 800F as either a stereo or dual mono amplifier. The XR 800F is shipped from the factory in the default setting of Left Main to the upper EQ and Right to the lower EQ. When this switch is depressed it switches the lower EQ to (mono) PA Left + Right. The upper EQ then becomes the Monitor signal only, creating an entire PA and Monitor mixing system in one small, easyto-carry package. POWER LED: The power on LED indicator will light when the unit is powered. SIGNAL LEVEL METERS: Displays overall level of either the L and R signals or the Mon and L+R (mix) signals. the System Mode Switch determines which mode the meter will operate in. Red Clip LEDs are located at the top of each meter to indicate clipping. When in Main/Monitor mode [see System Mode Switch (20)] the Monitor Fader controls the monitor signal present at the Left/Mon Power Amp Output (4). The Left and Right Faders would then control the L/R Mix present at the Right/L+R Power Amp Output (4). Most features are found on all channels, however, there are some differences in channel's 7, 8 and 9. Therefore, this section is divided to properly indicate those differences. MIC INPUT: XLR balanced, low impedance channel input optimized for a microphone or other low-level source. When the phantom power is enabled, this connector has +48 V on Pins 2 (in phase) and 3 with Pin 1 as the ground reference. The tip is the positive (in phase) input, which can also be used for unbalanced inputs. [. . . ] What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]