User manual PEAVEY XR 696F

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] You'll find enough features in the Master Section of the XR 684F/XR 696F to fit most sound reinforcement situations. Our audacious engineers (these guys are nuts) have been busy adding features to these products that you won't find in any other powered mixer. Adjust the two parameter controls (Time/Size and Color/Tone) to your desired settings. When you are satisfied with the new settings, push the Store button once. Now, twist the Preset Selector knob to one of the four locations provided and push the Store button again. When recalling any one of these four userdefined locations, keep in mind that the parameter settings are stored internally and may differ from where the actual knobs are physically set. Store LED: This yellow indicator blinks to indicate that you are in the Store mode. ) Effects Peak LED: This red LED illuminates to indicate 6 dB of headroom before the signals being sent to the effects circuit are clipped. When using a delay setting, this control adjusts the feedback or depth. efx to Mon: This control adjusts the amount of effects signal sent to the monitor mix. Important: To get the best performance from your new Peavey XR Powered mixer, you must let the Feedback Ferret "learn" each new room using the simple setup procedure described below. The Ferret, Peavey's award-winning feedback eliminator, is actually built into the XR 684F/XR 696F. the Ferret automatically applies 16 digital filters to control feedback within your setup. If you're operating your powered mixer in stereo mode, you can apply the Ferret to both the Left and Right channels. If, on the other hand, you're using your powered mixer for both Mains and Monitors, the Ferret can eliminate feedback from both. To setup the Ferret, first make sure everything is hooked up properly--all microphones, speakers, etc. Also, make sure all controls are set as they will be during performance but with the Masters down. Next, enter the Ferret Setup mode by pushing the button (the light goes off) and holding it until the light blinks once, and then release. When this switch is depressed, the first power amp is assigned to the Monitors and the second amplifier now becomes a mono Main (Left and Right combined). in this setting , one channel of the Ferret is assigned to the Monitor and one channel is assigned to the Main signal. Note that when this switch is depressed, the Left and Right preamp out jacks as well as the Right/Main power amp out are now mono. They are also post Feedback Ferret #1 and the Monitor out jack is now post Feedback Ferret #2. [. . . ] 02% @ rated output @ 1kHz DDT Dynamic Range: Greater than 26dB DDT Maximum Distortion: Below 0. 5% THD for 6dB overload Below 1% THD for 20dB overload Hum and Noise: 95dB below rated power level (210w) Damping Factor: Greater than 100 @ 1kHz, 4 ohms Input Sensitivity: 1. Power Amplifier Specifications: Power Section: 1200 SC Module with DDT Rated Power: 600W program into 4 ohms, both channels driven/500W RMS into 4 ohms, both channels driven 475W program into 8 ohms, both channels driven/360W RMS into 8 ohms, both channels driven Frequency Response: 20Hz­20kHz +0dB, -1dB @ rated power Total Harmonic Distortion (THD): <0. 01% @ rated output @ 1kHz DDT Dynamic Range: Greater than 26dB DDT Maximum Distortion: Below 0. [. . . ]