User manual PEAVEY XR 600G

[. . . ] B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] If you notice distortion from a particular channel or if the channel becomes loud very quickly, try engaging this switch. In addition to increasing the dynamic range, the channel input can now accommodate a higher input level before clipping occurs. This may be necessary when close-mic'ing a loud guitar amp or drum kit. Level & Signal/Clipping Indicator: Sets the signal level sent to the main mix. The bi-color LED is green when signal is present and red when clipping occurs. If the channel clips when turning the Level control up only slightly, try engaging the Pad switch (3). Mon (monitor): Controls the level of each channel signal (pre-EQ) that is added to the monitor mix. low EQ: A shelving type of active tone control that varies the bass frequency levels (±15 dB at 70 Hz). This control is designed to remove noise or add brilliance to the signal depending on the quality of the source. Efx: This control varies the level into the digital effects processor bus, adjusting signal level from the individual channel to the digital processor. The inputs are summed to mono, allowing a stereo source to be input into these channels. In critical situations, two mono line sources can be connected to one input. Line In: This pair of RCA phono jacks accepts a stereo input (nominally -10 dBV) from the output of a tape deck, CD player or other similar device. Line Out: This pair of RCA phono jacks provides a signal for the recording inputs of a stereo tape, CD player or other similar device. Take a break, mute channels 1­6 without changing the mic level settings. You'll find enough features in the Master Section of the XR600G to fit most sound reinforcement situations. Our audacious engineers (these guys are nuts) have been busy adding features to these products that you won't find in any other powered mixer. Medium Concert Hall Larger Concert Hall Darker Intimate Room Bright Larger Room Darker Bright Darker Large Space, Long and Darker Classic Spring Single Delay (Slap-back) Warm Delay with Repeats Dark Delay with Repeats Warm Delay Single Delay, 30 - 120 ms Warm Delay with Modulation Brightens and adds Room Reverb Brightens and adds Spring Reverb Effects Input CLip LED: This red LED illuminates to indicate 6 dB of headroom before the signals being sent to the effects circuit are clipped. Slowly bring the corresponding slider down until the feedback is gone. The LED will remain illuminated for a few seconds after the feedback is gone. If the feedback doesn't return, all the LEDs will become active again acting as a normal EQ. EQ Assignment: This switch allows you to patch the second (top) EQ to either the Monitor or to Channel 1. [. . . ] What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]