User manual PEAVEY XM 4

[. . . ] Mention of software products manufactured by other companies does not necessarily constitute endorsement by the manufacturer . While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein. The most up-to-date drivers and manuals are available from the web site: http://www. okiprintingsolutions. com Trademark Information Oki is a registered trademark of Oki Electric Industry Company Ltd. Other product names and brand names are registered trademarks or trademarks of their proprietors. 2 Contents Safety, Warnings and Cautions . [. . . ] If the battery pack is fully charged but runs out quickly, replace it with a new battery. Charging Time It takes about 1. 5 hours for a fully discharged battery pack to return to a fully charged state. Charging with the Optional AC Adapter Note: These instructions assume that the battery is installed in the printer (see "Installing the Battery Pack" below. Remove the printer's DC input jack (1) cover and connect the DC output terminal (2) on the AC adapter (3) to it. 26 2. When the battery pack is fully charged, the battery indicator goes off. Note: In the case of the Wireless LAN interface model, the Battery Strength segments (see page 51) on the LCD screen will appear when charging starts, and go off when charging is complete. Charging Time With the AC adapter, it takes about 5 hours for the battery pack to reach full charge from a fully discharged state. 27 Installing the Battery Pack 1. Press the POWER button to turn the printer off. POW ER PR INT FE ED 1. Turn the printer upside down and unlatch the battery compartment cover. 28 2. Align the battery pack so that its metal terminals (1) are facing the printer and the tab (2) on the battery is up, then insert the battery until it snaps in place. 3. Close the battery cover. 29 Removing the Battery Pack Important!: Remove the battery pack only when the printer is turned off. Confirm that the leading edge of the label is outside the printer by at least 10 mm, then close the cover. m 10 m Note: When using linerless labels, press the FEED button to feed a piece of label and pull the label upward to cut it along the perforation. Push the dispenser unit forward so that it covers the red platen roller. 40 Operation and Configuration Turning the Printer ON POW ER PR INT FE ED 1. When the STATUS LED (2) lights green, release the button Turning the Printer OFF POW ER PR INT FE ED 1. When the STATUS LED (2) goes off, release the button. 41 Performing a Test Print Important!: A low battery condition may affect the print quality. Make sure the printer is running on AC or on a full battery during a test print. Users can perform test prints to evaluate the print quality and also diagnose problems. Press and hold the FEED button (1), then press the POWER button (2) to turn the printer on. POW ER PR INT FE ED The printer enters the test mode. 42 3. Press the FEED button (1) again to start the test print. ABC 4567 abc DEFG defg 1 AB 2345 abcCDEF 67 defg G 123 4. Note: If any fault is detected, contact your Oki dealer or service center. Before asking for a repair, please read the Troubleshooting section of this manual. Press the POWER button to disenage the test mode and turn the printer off. 43 Printing Using via the RS-232C Interface 1. [. . . ] (See "Cleaning and Maintenance") Clean the platen and dispense roller. (See "Cleaning and Maintenance") Retry with different label paper. (See "Cleaning and Maintenance") Clean the platen and peel roller. (See "Cleaning and Maintenance") Check the connection of the RS232C cable connector (See "Printing" on page 44). [. . . ]