User manual PEAVEY WS 802 DATASHEET

[. . . ] ⷠRead and follow all warning and instruction labels on the product itself. If you place it on a soft surface, such as a rug, sofa, or cushion, the vents may be blocked, causing the product to overheat. [. . . ] Do not put the product on or near a heat source (such as a radiator or heat register). Allow enough room around the product for adequate ventilation and easy access to the paper trays. If you put the product in any kind of enclosure, make sure the enclosure is well ventilated. ⷠBe certain that your power source matches the rating listed on the back of the product. If you are not sure, check with your dealer or with your local power company. ⷠDo not connect this product to an uninterruptible power supply (UPS). If the plug does not fit, the outlet may be an older, non-grounded type. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radio Frequency Interference Statement WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Plug the unit into an outlet on a circuit different from that to which the receiver is connected. Note: It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Plug the unit into an outlet on a circuit different from that to which the receiver is connected. Note: It is the responsibility of the user to obtain the required shielded cable in order to ensure compliance of this equipment with FCC regulations. [. . . ]