User manual PEAVEY VSX II

[. . . ] B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] Each filter is independent, with the crossover frequency selected via a recessed knob, rotary control, to prevent accidental changing of the critical crossover frequency. Control range is from 60 Hz to 6 kHz and determines the -6 dB crossover point between the low- and high-frequency bands within the channel. In mono MODE this control determines the crossover point between the LOW and MID frequency bands. Each band-pass section features a level control to compensate for the various loudspeaker efficiency ratings. Adjusts the amount of boost within the HF band to compensate for the frequency roll-off and lost of efficiency with some compression drivers. The screwdriver shaft control provides a variable boost from 0 dB to +12 dB at 20 kHz, with first-order slope and excellent phase response. When engaged, reverses the polarity of the signal in the HIGH 1 frequency band to speed up trouble shooting and assure proper phase response of the audio system. This green LED indicates the presence of a signal higher than -22 dBu in the HIGH 1-band even if the band is muted. When engaged eliminates the signal in the HIGH 1 band, to help during the install of the audio system. This red LED indicates when the signal level in the HIGH 1 frequency band is approaching the maximum available headroom of +22 dBu. When this switch is depressed, VSXII is configured as a single channel, 3way, mono crossover. This yellow LED blinks (1Hz) continuously when the VSXII is in stereo mode. It also indicates the control functions for this MODE are depicted on the upper white strip. This yellow LED blinks (1 Hz) continuously when the VSXII is in mono mode. It also indicates the control functions for this MODE are depicted on the lower white strip. Used to optimize the interface gain between the VSXII Channel 2, and the associated mixer. Control range is -20 dB to +20 dB with Unity gain at center (detent) position. Provides a 24 dB per octave roll-off at 40 Hz to reduce subsonic rumble and to protect the low speaker from operating below its cutoff frequency. When not engaged, the low-end roll-off frequency of Channel 2 is below 10 Hz. When engaged, reverses the polarity of the signal in the Low frequency band to speed up trouble shooting and assure proper phase response of the audio system. This green LED indicates the presence of a signal higher than -22 dBu in the LOW 2-band even if the band is muted. When engaged, eliminates the signal in the LOW 2 band, to help during installation of the audio system. [. . . ] What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]