User manual PEAVEY TRANSTUBE 258 EFX

[. . . ] When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. " Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. [. . . ] The final level adjustment should be made after the desired sound has been achieved. The VINTAGE position changes the overall function of the EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with the EQ (11) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 6 for some creative starting points. Rotating this control clockwise changes the parameter of the active effect according to the descriptions below. To return to the factory settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on. Three types of delay are available: SLAP (1 repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the control indicate which type is active and volume level. Pressing the control twice sets the delay time to interval between presses. EFX SELECT MODE NOTE: When entering this mode, the current preset will remain active. In this mode, PRESET 1 (19) selects between the Lead and Clean channels. the CHANNEL LED (20) will illuminate when the Lead channel is active. PRESET 2 (22) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (21) as a status indicator, the "off" (or lower setting) should be made with the LED dark, and the "on" (or higher setting) As with effects settings, this switch may be used as an on/off for reverb and delay. PRESET SELECT MODE In this mode, all three switches control effects presets. Once desired settings are achieved utilizing the effects controls on the front panel, double-click one of the Preset switches (14, 22, or 24) to store the settings. To return to the last saved settings for a Preset, press the desired Preset switch once. For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section of this manual on the following page. In addition to the adjustments described in the EFX ADJ PARAMETERS section of this manual, additional tweaks may be made to customize effects to user preference. [. . . ] Headphone Output: Load Impedance: 8 Ohms or greater Nominal Power Output: 20 mW into 8 Ohms (Stereo jacks, monaural signal disconnects internal speaker when phone plug is inserted. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]