User manual PEAVEY TRANSCHORUS 210

[. . . ] Scan through this manual and locate these safety icons: Each safety icon is followed by a warning. Once you have read all of the warnings, refer to the ÒQuick StartÓ section below if you so desire. It is recommended that you read this manual in its entirety to fully understand the functions of each feature. The following section takes a Òjump in and get your feet wetÓ approach. [. . . ] Lead Channel Pregain (11) Controls the input level of the Lead channel. Adjusting this control clockwise will increase the input level, thus increasing distortion. mid Boost Switch (12) When activated (in) , this switch boosts the mid frequencies. This effect is often desired when miking an amp that is producing distorted guitar signals. This effect is often used to get intentional feedback and increased sustain. The desired tone and distortion level should be obtained prior to adjusting this control for proper level. Adjusting these knobs clockwise will pass more low, mid, or high frequency content of these to the internal power amps . Reverb (16) Adjusting this control clockwise will result in more reverb content in the output of the amp regardless of the channel. The reverb can be defeated completely by rotating the control counter clockwise. rate (17) Adjusting this control clockwise will result in an increase in the sweep rate (frequency) of the chorus effect. This control adjusts the amount of chorus you actually hear from the output of the amp. Dynamics¨ (19) This control adjusts the usable power of the internal power amps from 10% (counter clockwise) to 100% (clockwise). This effect is often set to lower levels in order for the power amp compression simulation to be more apparent, allowing you to overdrive the power amp at lower volume levels, achieving a tube power amp clipping/compression quality. Power Switch (21) Placing this switch in the ÒONÓ position will result in power being supplied to the unit. Plugging a set of headphones into this jack will disconnect the signal going to the power amplifiers of the unit, and no output can be heard from the unitÕs speakers. Power Amp In (23) These left and right mono 1/4" jacks provide an input to each of the power amplifiers. When used in conjunction with the Preamp Out jacks (24), a stereo effects loop is formed allowing the use of stereo delays and various effects. Preamp Out (24) These left and right mono 1/4" jacks provide an output from each of the preamps. When used in conjunction with the Power Amp In jacks (23), a stereo effects loop is formed allowing the use of stereo delays and various effects. To use the footswitch ensure that the footswitch plug is inserted fully into the jack and that the Select switch is pressed in (down position) on the front panel. AC LINE CORDÑ120 V PRODUCTS ONLY (26) For you safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities. If it is necessary to use the equipment without proper grounding facilities, suitable grounding adapters should be used. [. . . ] What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]