User manual PEAVEY STUDIOMIX QUICK START

[. . . ] NOTE: FOR UK ONLY As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or color red. The TransTube preamp on your amplifier consists of three clearly labeled sections: Inputs, Clean (channel) and Lead (channel). [. . . ] Position changes the overall function of the EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with Clean EQ (9) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 11 for some creative starting points. Clean EQ The TransTube EQ featured on the Clean channel of your amp offers 3-band tone adjustment. Each EQ control is passive (does not add gain) and has a frequency range dependent on the position of the Modern/Vintage Switch. Reducing the control to the "0" position (fully counterclockwise) introduces maximum cut in level for the particular band. This control is often used to adjust the amount of distortion present in the Lead channel. modern/Vintage/High Gain- Switch This switch changes both the gain and voicing of the Lead channel. Selecting the MODERN setting increases the overall gain and notches (cuts) the mid frequencies to establish a modern tone often associated with Hard Rock and Metal styles. This creates a tighter response at lower Pre Gain settings or an "over the top" sound at higher Pre Gain settings. Experiment with this switch setting while adjusting the Lead EQ (12) to help you obtain your desired tone. Power Amp In Connect line level signals from external equipment to this input. Inserting a plug into this mono 1/4" jack will prevent the TransTube preamp signal from being sent to the amplifier. In this configuration, the power amp only amplifies the signal introduced at the Power Amp In jack. effects Level This switch selects the Effects Loop (20) operating level. When the switch is pressed to the "in" position the level is set for 0 dBV (1 V RMS). Placing the switch to the "out" position changes the level to -10 dBV (0. Refer to the owner's manual for your external effects to determine the correct position for this switch. Ground Switch Place this switch in the center position (0) during normal operation. If audible hum occurs, position the ground switch in either the positive (+) or negative (-) position to minimize the noise. The settings illustrated above are also applicable to the Envoy 110 and Studio Pro 112, with the exception of the resonance and presence controls. Greater than -86 dB below rated power (20 Hz to 20 kHz unweighted) Greater than 78 dB below rated power The following specs are measured @ 1 kHz with the controls preset as follows: Channel Select, Clean Clean Mode Switch, Modern Low and High @ 10 Mid @ 0 Lead Pre and Post Gain @ 10 Lead Mode Switch, Vintage Reverb @ 0 Nominal Levels are with Clean Volume @ 5 Minimum Levels are with Clean Volume @ 10 Specifications subject to change without notice. [. . . ] When the provided plug does not fit into your inlet, consult an electrician for replacement of the obsolete outlet. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. [. . . ]