User manual PEAVEY STUDIO PRO 112

[. . . ] Please read this manual in its entirety to ensure optimum and safe operation of your new TransTube amp. Two distinct TransTube channels each featuring: · Spring reverb with reverb level control · 100 watt power amplifier (80 watts into internal speaker) · In order to apply power to your TransTube Series amp you must first identify its required AC supply voltage. The proper voltage for your unit is labeled on the upper left corner of the rear panel. AC Power Cord (Under Chassis) Locate the power cord tucked into the rear speaker compartment. [. . . ] Lead EQ The TransTube EQ featured on the Lead channel of your amp offers 3-band tone adjustment. Each EQ control is passive (does not add gain) and has a frequency range dependent on the position of the Modern/Vintage/High Gain Switch. Reducing the control to the "0" position (fully counterclockwise) introduces maximum cut in level for the particular band. Post Gain Use this control to set the overall level of the Lead channel once your tone has been achieved. It is best to start with the control fully counterclockwise (minimum gain) and adjust clockwise until the desired level is achieved. After all EQ and voicing adjustments have been made to the channel, you may wish to reset this control. note: Reverb can be defeated by the Remote Switch (18) on the Envoy 110 and Studio Pro 112 models. T-Dynamics® This control adjusts the power level of the amplifier from 10 percent to 100 percent power. When set to lower settings, the power compression simulation will be much more pronounced. presence This active tone control boosts the extreme high frequencies by as much as 6 dB. Resonance Use this switch to set the low frequency resonance of the speaker enclosure by varying the damping factor of the amplifier between two settings, TIGHT and LOOSE. in the TIGHT position , the amlifier has a higher damping factor causing the speaker/cabinet combination to resonate less. The LOOSE position allows the characteristics of the power amp/cabinet/speaker combination to resonate more at low frequencies. Thus, the resonant frequency of the cabinet is used to produce more low end, simulating a larger cabinet. Using this jack defeats the output to the speaker making it ideal for quiet practice applications. Effects Loop This pair of mono 1/4" jacks supply an effects SEND and RETURN path for the preamp signal. connect the SEND jack to the input of external , low-level , signal processing equipment (effects). This is known as an Effects Loop since the signal exits your amp (send) and loops (return) back to it. On the Bandit 112, the effects loop can be swapped in and out of the signal path using the supplied Remote Switch (18). This jack disconnects internal speaker when used on Studio Pro 112 Preamp Out The Preamp Output can be used to route the preamp signal to a mixing console, tape recorder, etc. [. . . ] What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]