User manual PEAVEY SPECIAL 212

[. . . ] This, in combination with resonance and presence circuitry, yields the closest tube amp simulation to date. This compression effect is increased by turning the T-Dynamics'" control down, which lowers the power level the amp puts out. To further enhance the performance of the Special 212, an added speaker jack along with a footswitchable effects loop allows for even greater flexibility. [. . . ] connect the preamp output using a shielded cable to an input of the tape recorder , mixer , etc. When using remote footswitch, always insert the plug fully (second click) to ensure proper operation. Dynamics @ 100% 130 W RMS into 8 ohms 220 W RMS into 4 ohms Power @ Clipping: (typically) (5% THD, 1 kHz, 120 V AC line) 130 W RMS into 8 ohms 220 W RMS into 4 ohms Frequency Response: +O, 3 dB, 60 Hz to 20 kHz, @ 100 W RMS into 8 ohms Hum 81 Noise: Greater than 86 dB below rated power Power Consumption: Domestic: 600 W @ 60 Hz, 120 VAC Export: 600 W @ 50/60 Hz, 220-2301240 V AC PREAMP SECTION The following specs are measured @ 2 kHz with the controls preset as follows: Push Bright, Off (out) Channel Select Normal (out) Low& High @ IO Mid @ 0 Resonance & Presence @ 0 dB Pre & Post Gain @ IO Gain 6: Thrash, Off (out) Normal Levels are with normal volume @ 5 Minimum Levels are with normal volume @ IO Shift, Off (out) Bottom, Body, & Edge @ 0 T-Dynamics @ 100% (Switching jack provides preamp output to power amp input connection when not used) System Hum & Noise @ Nominal Input Level: (20 Hz to 20 kHz un weigh ted) 72 dB below rated power Equalization: Special Low, Mid, & High passive type EQ Special Bottom, Body, & Edge EQ Push Bright: +6 dB @ 2 kHz Push Shift: Shifts Ultra Channel Body Frequency Push Thrash: -20 dB notch @ 1 kHz in Lead channel Push Gain: Increases Lead or Ultra gain Resonance: +6 dB @ cabinet resonance Presence: +6 dB @ 5 kHz External Footswitch Functions: Lead/Ultra Select (when Channel Select button is in) Clean Bypass Effects Loop Bypass Dimensions 81 Weight: 20. Due to our efSorts, for constant improvements, , feutures and specifications LiJ ted herein are subject to charge without notice. For further information on other Peavey products, ask your Authorized Peavey Dealer for the appropriate Peavey catalog/publication. PEAVEY ONE-YEAR LIMITED WARRANTY/REMEDY PEAVEY ELECTRONICS CORPORATION ("PEAVEY") warrants this product, EXCEPT for covers, footswitches, patchcords, tubes and meters, to be free from defects in material and workmanship for a period of one (1) year from date of purchase, PROVIDED, however. That this limited warranty is extended only to the original retail purchaser and is subject to the conditions, exclusions, and limitations hereinafter set forth: PEAVEY 90-DAY LIMITED WARRANTY ON TUBES AND METERS If this in material and workmanship for contains tubes or meters, Peavev warrants the tubes or meters contained in the oroduct to be free from a period of ninety (90) days from date of purchase; PROVIDED, however, that this limited warranty is extended only to the original retail purchaser and is also subject to the conditrons, exclusions, and limitations hereinafter set forth. cONDITIONS , EXCLUSIONS , AND LIMITATIONS OF LIMITED WARRANTIES These limited warranties shall be void and of no effect , if: a. The original retail purchase is not made from an AUTHORIZED PEAVEY DEALER; or c. The product has been damaged by accident or unreasonable use, neglect, improper service or maintenance, or other causes not arising out of defects in material or workmanship; or d. the serial number affixed to the product is altered , defaced , or removed. In the event of a defect in material and/or workmanship covered by this limited warranty, Peavey will: a. , cases involving anything other than covers, footswitches, patchcords, tubes or meters), repair the defect in material or workmanship or replace the product, at Peavey's option; and provided, however, that, in any case, all costs of shipping, if necessary, are paid by you, the ourchaser THE WARRANTY REGISTRATION CARD SHOULD BE ACCURATELY COMPLETED AND MAILED TO AND RECEIVED BY PEAVEY WITHIN FOURTEEN (14) DAYS FROM THE DATE OF YOUR PURCHASE. In order to obtain service under these warranties, vou must: Bring the defectrve item to any PEAVEY AUTHORIZED DEALER or AUTHORIZED PEAVEY SERVICE CENTER and present therewith the ORIGINAL PROOF OF PURCHASE supplied to you by the AUTHORIZED PEAVEY DEALER in connection with your purchase from him of this product. [. . . ] This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. For more information on grounding, write for our free booklet "Shock 9. [. . . ]