User manual PEAVEY RQ 2300

[. . . ] Connect the 1 line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line voltage is used. When lost or damaged, replace this cord with one of the proper ratings. NOTE: FOR UK ONLYAs the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and Yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. [. . . ] the RQ Series mixer you have purchased utilizes multiple channel configurations. It is important that you recognize these differences in order to take advantage of each channel's features and avoid confusion. MIC INPUT: XLR balanced low impedance channel input optimized for a microphone or other low impedance source. Because of the wide range of gain adjustment, signal levels up to +10 dBu can be accommodated. lINE INPUT: 1/4" balanced (TRS) high impedance input for high level signals. The tip is the positive input, which should also be used for unbalanced inputs. INSERT: Channels 1 -- 4 (RQ 2310), 1 -- 8 (RQ 2314) and 1 -- 12 (RQ 2318) 1/4" stereo (TRS) jack which allows an external device to be inserted into the signal path before the tone equalization. When plugged in partway (first click), the jack can be used as a pre-amp output without interrupting the channel. It should be set by depressing the PFL switch (53) and adjusting it for a 0 dBu level at the L-R meters. On the first six channels of the RQ 2310 (first 10 channels - RQ2314, first 14 channels - RQ2318), the frequency of the boost or cut is set by the Mid Frequency control (43). This is a mono mix of the left and right signals in the stereo channels. This is a mono mix of the left and right signals in the stereo channels. It is post-fader, designed for use as an effects send, that can also be used for another monitor send. It is post-fader, designed for use as an effects send, that can also be used for another monitor send. The PFL signal is independent of this switch, and can be used to check the channel and adjust its input gain even when muted. If the Mute switch (50) is depressed, it lights continuously to indicate that this channel has been muted. sIGNAL/PFL LED (yellow): Normally indicates that a signal is present in the channel of ­20 dBu or greater. If the PFL switch (53) is depressed, it lights continuously to indicate that this channel has been assigned to the PFL mix. In these two channels all controls are identical to the previous channels with the exception of the insert jack. This will increase the dynamic range to accommodate a higher input level before clipping which may be necessary when close miking loud guitar amplifiers or drum kits. [. . . ] If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]