User manual PEAVEY PV 35XO

[. . . ] B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] This control is used to optimize the channel 2 gain between the mixer and the power amps for channel 2. While there should be no problem if this indicator flashes occasionally, it should never flash constantly or stay illuminated. This allows users to choose their desired crossover points for lows and the low side of the mids for channel 2. This switch multiplies the value indicated on the Crossover Selector control for the lows and the low side of the mids times 10. When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. This allows users to choose their desired crossover points for the high side of the mids and the highs for channel 2. This switch multiplies the value indicated on the Crossover Selector control for the high side of the mids and the highs times 10. When engaged, the range will change from 80 Hz - 900 Hz to 800 Hz - 9 kHz. This controls the output level of the channel 2 low frequency signal (signal below the selected low/mid crossover point) present at channel 2 low output XLR. This controls the output level of the channel 2 mid frequency signal (signal above the selected low/mid crossover point and below the selected mid/high crossover point) present at channel 2 mid output XLR. This controls the output level of channel 2 high frequency signal (signal above the selected mid/high crossover point) present at channel 2 high output XLR. This 2-position rocker switch applies mains power to the unit when in the ON position. This XLR female 3-pin connector provides a balanced input for channel 1. This XLR male 3-pin connector provides a balanced output for the low frequencies for channel 1. This XLR female 3-pin connector provides a balanced input for channel 2. This XLR male 3-pin connector provides a balanced output for the low frequencies for channel 2. an AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. [. . . ] This controls the output level of high frequency signal (signal above the selected high-mid/high crossover point) present at high output XLR. This 2-position rocker switch applies mains power to the unit when in the ON position. This XLR male 3-pin connector provides a balanced output for the low frequencies. This XLR male 3-pin connector provides a balanced output for the low side of the mid frequencies. [. . . ]