User manual PEAVEY PV 23XO

[. . . ] B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. [. . . ] This controls output level of channel 2 highs signal (signal above the selected crossover point) present at channel 2 high output XLR. This allows users to choose their desired crossover point for lows and highs for channel 2. This switch multiplies the value indicated on the Crossover Selector Control times 10. When engaged, the range will change from 100 Hz to 1 kHz through 1 kHz to 10 kHz. an AC mains cord having the appropriate AC plug and ratings for the intended operating voltage is included in the carton. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always make sure that the equalizer and all associated equipment is properly grounded. If for any reason you are unable to power up this unit, remove the fuse by pulling out the holder. If the fuse continues to fail contact your nearest Certified Peavey Service Center. This XLR female 3-pin connector provides a balanced input for channel 1. This XLR male 3-pin connector provides a balanced output for the low frequencies for channel 1. This XLR male 3-pin connector provides a balanced output for the low frequencies for both channel 1 and channel 2, which been summed (added) together. This XLR female 3-pin connector provides a balanced input for channel 2. This XLR male 3-pin connector provides a balanced output for the low frequencies for channel 2. This 2-position rocker switch applies mains power to the unit when in the ON position. This switch selects between stereo 2-way operation and mono 3-way operation. This control is used to optimize the gain between the mixer and the power amps. This controls the output level of low frequency signals (those below the selected crossover point) present at the low output XLR. [. . . ] If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. [. . . ]