User manual PEAVEY HDH

[. . . ] Damage to the equipment may occur if improper line voltage is used (see voltage marking on unit). NOTE: FOR UK ONLY As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or color red. [. . . ] POWER SWITCH (See front panel diagram next page) Place this switch in the "ON" position to turn the unit on. POWER LED (See front panel diagram next page) Illuminates when AC power is being supplied to the mixer. This section will help you locate the two speaker output jacks on the rear of your HDH. SPEAKER OUTPUTS Two parallel 1/4" jacks are provided at the output of the power amplifier for ease of speaker connection. MIC (LOW Z) INPUT XLR balanced low impedance channel input optimized for a microphone or other low impedance source. This connector has +15V phantom power supply on Pins 2 and 3 at all times (Pin 1 is the ground reference). LINE (HIGH Z) INPUT 1/4" unbalanced input that accepts line level sources equipped with a 1/4" plug (TS). REVERB Sets the level of the internal reverb for the channel and must be used in conjunction with the master reverb level. EQ boost is obtained by moving a particular EQ band's control above the "0" position. EQ cut is obtained by moving a particular EQ band's control below the "0" position. The following list describes each EQ control and its center frequency. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. If you have any questions about this warranty or service received or if you need assistance in locating an Authorized Service Center, please contact the Peavey International Service Center at (601) 483-5365 / Peavey Canada Ltd. WARNING: When using electric products, basic cautions should always be followed, including the following: 1. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. When the provided plug does not fit into your inlet, consult an electrician for replacement of the obsolete outlet. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. [. . . ] When the provided plug does not fit into your inlet, consult an electrician for replacement of the obsolete outlet. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. [. . . ]