User manual PEAVEY EXPRESS 112

[. . . ] This, when combined with the preamp circuitry, yields the closest tube amp simulation to date. If both inputs are used simultaneously, the output levels are the same (both are Low Gain). The final level adjustment should be made after the desired sound has been achieved. [. . . ] When set to lower settings, the power compression simulation will be much more pronounced. The red pilot light (LED) will illuminate indicating power is being supplied to the unit. M For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities. If it is necessary to use the equipment without proper grounding facilities, suitable grounding adaptors should be used. Less noise and greatly reduced shock hazard exists when the unit is operated with the proper grounded receptacles. When using remote footswitch, always insert the plug fully (second click) to insure proper operation. Dynamics @ 10 65 W RMS into 8 ohms 4 ohms not recommended Low&High @ 10 Mid @ 0 Pre & Post Gain @ 10 Gain & Thrash, Off (Out) Normal Levels are with normal volume @ 5 Minimum Levels are with normal volume @ 10 (20 Hz to 20 kHz unweighted) 68 dB below rated power Greater than 78 dB below rated power Lead Channel Defeat (when selected with button) Reverb Defeat The following specs are measured @ 1 kHz with the controls preset as follows: Afin d'assurer un bon fonctionnement lors de l'utilisation de l'interrupteur au pied, inserez la fiche a fond jusquau second cran (au second clic). For further information on other Peavey products, ask your Authorized Peavey Dealer for the appropriate Peavey catalog/publication: Bass Guitars Guitars Bass Amplification Guitar Amplification Sound Reinforcement Enclosures Microphones Keyboards 00 or an amount equal to the purchase price of the product that caused the damage or that is the subject of or is directly related to the cause of action. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. For more information on grounding, write for our free booklet "Shock Hazard and Grounding. Periodically check cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit. The power supply cord should be unplugged when the unit is to be unused for long periods of time. If this product is to be mounted in an equipment rack, rear support should be provided. The vinyl covering used on some units can be cleaned with a damp rag or an ammoniabased household cleaner if necessary. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This product should be used only with a cart or stand that is recommended by Peavey Electronics. [. . . ] Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This product should be used only with a cart or stand that is recommended by Peavey Electronics. Exposure to extremely high noise levels may cause a permanent hearing loss. [. . . ]