User manual PEAVEY DELTAFEX TWIN

[. . . ] Dieses Symbol soll den Benutzer auf wichtige Instruktionen in der Bedienungsanleitung aufmerksam machen, die Handhabung und Wartung des Produkts betreffen. VORSICHT: Um das Risiko eines elektrischen Schlages zu vermeiden, nicht die Abdeckung enfernen. Es befinden sich keine Teile darin, die vom Anwender repariert werden könnten. Reparaturen nur von qualifiziertem Fachpersonal durchführen lassen. [. . . ] (See voltage marking on unit. ) Never remove or cut the ground pin of the line cord plug. When lost or damaged, replace this cord with one of the proper ratings. 3 NOTE: FOR UK ONLY As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or the color red. The Status/Power LED (22 ) on the front of the unit will illuminate to indicate the unit is on. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the unit repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. CAUTION: USING A FUSE LARGER THAN THE RECOMMENDED SIZE COULD RESULT IN PERMANENT DAMAGE TO THE AMPLIFIER. (4) SPEAKER JACKS Two paralleled 1/4" speaker jacks are provided for connection to speaker enclosures. The minimum speaker load impedance is 4 ohms. (3) FRONT PANEL: 5 6 9 10 11 12 13 14 15 7 8 16 17 18 19 20 21 22 FRONT PANEL FEATURES (5) INPUT JACK This mono 1/4" input will accept signals from all types of bass pickups. The LED illuminates red when DDT power amp compression is taking place. When DDTTM is defeated, the LED will illuminate red when clipping occurs. (21) (22) 6 DeltaBassTM Specifications NOTE: All specifications measure with mains voltage maintained at nominal level. Mains Voltage = 120 VAC 60 Hz (Fuse: 5 amps) 230 VAC 50/60 Hz (Fuse: 3. 5 amps) 100 VAC 50/60 Hz (Fuse: 6 amps) Power Consumption = 200 watts PREAMPLIFIER SECTION: SETTINGS FOR FOLLOWING MEASUREMENTS UNLESS OTHERWISE NOTED: Pre-Gain = 5 (12 o'clock) Contour = 0 (fully CCW) Bass = 0 (12 o'clock) Mid = 0 (12 o'clock) Mid Shift = 12 o'clock High = 0 (12 o'clock) Master Volume = 5 (12 o'clock) High Boost = out Pad = out DDTTM = Active SYSTEM NOISE: Typically greater than -85 dB POWER AMPLIFIER SECTION: Protection: Current limit protection circuit. DDTTM speaker protection circuit with defeat switch. INPUT SENSITIVITY (Level to achieve full power): With Pad Out. . . Nominal input: 65 mv Minimum input: 3 mv (pre gain and master fully CW) Maximum input: 2. 3 volts (maximum signal at input before clipping occurs) With Pad (-10dB) In. . . Nominal input: 205 mv Minimum input: 9. 5 mv (pre gain and master fully CW) Maximum input: 7. 2 volts (maximum signal at input before clipping occurs) GENERAL INFORMATION: Minimum load = 4 ohms DDTTM dynamic range: +12 dB Input sensitivity: 1 V RMS Two 1/4" output jacks in parallel. POWER OUTPUT: 160 watts (25. 3 V RMS) into 4 ohms with no more than 0. 1% THD+N 175 watts (26. 46 V RMS) into 4 ohms @ 1% THD+N 110 watts (29. 66 V RMS) into 8 ohms with no more than 0. 1% THD+N 120 watts (30. 98 V RMS) into 8 ohms @ 1% THD+N EQUALIZATION: Contour: special EQ curve Bass: +/-15 dB (shelving type) Midrange: +/-15 dB (peaking type) Mid Shift: 200-2 kHz High: +/- 15 dB (shelving type) High Boost: + 10 dB @ 8 kHz NOISE: Greater than 100 dB below full power @ 8 ohms typically -105 dB EFFECTS LOOP: Set for -10 dB with pre @ 5, Master @ 10 TUNER SEND: Buffered off input jack with no equalization. XLR OUTPUT (referenced to 1 V RMS = 0dBv): Pre-Eq selected: -2 dBv Post-Eq selected: -3 dBv 7 DeltaBassTM Recommended Settings Rock Setting Set as necessary In Set to appropriate level for instrument being used Doesn't matter when Mid is set to 0 Slap Setting Set as necessary to In Set to appropriate level for instrument being used Blues/Country Setting Set as necessary Out Set to appropriate level for instrument being used NOTE: DDT should be utilized for maximum speaker protection. NOTE: DDT should be utilized for maximum speaker protection 8 NOTES: 9 PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY Effective Date: July 1, 1998 What This Warranty Covers Your Peavey Warranty covers defects in material and workmanship in Peavey products purchased and serviced in the U. S. A. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. How Long This Warranty Lasts The Warranty begins on the date of purchase by the original retail purchaser. The duration of the Warranty is as follows: Product Category Guitars/Basses, Amplifiers, Pre-Amplifiers, Mixers, Electronic Crossovers and Equalizers Drums Enclosures Digital Effect Devices and Keyboard and MIDI Controllers Microphones Speaker Components (incl. [. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ]