User manual PEAVEY CS 2000

[. . . ] For more information on other great Peavey products, visit your local Peavey dealer or go online to www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases, should not be placed on this apparatus. Before using this apparatus, read the operating guide for further warnings. [. . . ] connecting Outputs All models have two output (speaker) connections per channel. Cables can be connected with banana plugs, spade lugs, or bare wire to the five-way binding posts. Connecting Power CS Series amplifier power requirements are rated at 1/8 power (typical music conditions) and 1/3 power (extreme music conditions). The maximum power current draw rating is limited only by the front panel circuit breaker. consult the specifications in the Appendices section for figures on the current that each amplifier will demand. Unless otherwise specified when ordered, Peavey amplifiers shipped to customers are configured as follows: North America South America 120VAC/60Hz 230/240VAC/60-50Hz 120VAC/60Hz or 240VAC/50Hz Europe, Asia, Australia - Note: Always turn off and disconnect the amplifier from mains voltage before making audio connections. Stereo Operation For stereo (dual channel) operation, turn the amplifier OFF and set the mode select switches on the back panel to the out (extended) position. In this mode, both channels operate independently of each other, with their input attenuators controlling their respective levels. thus , a signal at channel A's input produces an amplified signal at channel A's output , while a signal at channel B's input produces an amplified signal at channel B's output. Bridged Mono Operation Both amplifier channels can be bridged together to make a very powerful single-channel monaural amplifier. Use extreme caution when operating in the bridged mode; potentially lethal voltage may be present at the output terminals. Only channel A's input attenuator is active while in Bridge Mono mode. Unlike the stereo mode, in which one side of each output is at ground, both sides are hot in bridged mode. Channel A's side is the same polarity as its input with the minimum nominal load impedance being 4 ohms (equivalent to driving both channels at 2 ohms) in bridged mode. Driving bridged loads of less than 4 ohms will activate the DDTTM circuitry (see Indicators section), resulting in a loss of power, and may also cause a thermal (overheating) overload. If the switch shuts off during normal use, push it back to the ON position once. If the switch will not stay in the ON position, the amplifier needs servicing. input Attenuators (2) Whenever possible , set the attenuators fully clockwise to maintain optimum system headroom. The input attenuator controls (one for channel A, one for channel B) located on the front panel attenuate signal level (decrease gain) for the respective amplifier channels in all modes. Do not operate the Bridge Select switch with the amplifier powered on. [. . . ] It is your responsibility to read the Important Precautions section and to make sure that the amplifier is installed, wired and operated properly as instructed in this manual. Many loudspeakers can be easily damaged or destroyed by overpowering, especially with the high power available from a bridged amplifier. Read the Speaker Protection section and always be aware of the speaker's continuous and peak power capabilities. In the unlikely event that your amplifier develops a problem, it must be returned to an authorized distributor, service center or shipped directly to our factory. [. . . ]