User manual PEAVEY CLASSIC 30

[. . . ] This input produces enhanced high frequency response (treble), similar to a bright switch when compared to the normal input. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. Three position rocker-type switch which, in most applications, should be operated in its center or zero position. [. . . ] Three position rocker-type switch which, in most applications, should be operated in its center or zero position. There may be some situations when audible hum and/or noise will come from the loudspeaker. If this situation arises, position the ground switch to either positive or negative ( + or -) or until the noise is minimized. NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a qualified service technician. When using remote footswitch, always insert the plug fully (second click) to ensure proper operation. The following specs are measured @ 1 kHz with the controls preset as follows: (5% THD, 1 kHz, 120 V AC line) 50 W RMS into 16 or 8 ohms (Bias must be reduced to measure) Pre & Post (lead) @ 0 Reverb Level @ 0 Bass & Treble EQ @ 12 Middle EQ @ 0 Master Volume @ 12 Presence @ 6 Nominal level is with Input Gain @ 6 Minimum levels is with Input G a i n @ 12 Greater than 80 dB below rated power Tone settings given are general and will vary according to type of guitar, type and guages of strings, type of pickup and even type of pick. Personal taste, playing style, and type of music greatly contribute to desired tonahty. STANDBY SWITCH (Interruptor de condicih de espera) (2) Este interruptor le permite a su aparato estar en condition de"espera" o la condition de active. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. For more information on grounding, write for our free booklet "Shock Hazard and Grounding. Periodically check cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit. The power supply cord should be unplugged when the unit is to be unused for long periods of time. The vinyl covering used on some units can be cleaned with a damp rag, or an ammonia-based household cleaner if necessary. If this product is to be mounted in an equipment rack, rear support should be provided. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. [. . . ] If this product is to be mounted in an equipment rack, rear support should be provided. Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings. This product should be used only with a cart or stand that is recommended by Peavey Electronics. [. . . ]