User manual PEAVEY 1210TS DATASHEET

[. . . ] Hold the chassis (top and bottom) tightly and turn the instrument the right way up. Grasp the extreme top ends of the lid and lift it off by following the sequence of illustrations A, B and C. Rear / Dietro (A) Lift up Sollevare (B) Pull towards you to clear the keyboard. [. . . ] Rear / Dietro (A) Lift up Sollevare (B) Pull towards you to clear the keyboard. Hold the chassis (top & Bottom) tightly and turn the instrument the right way up, lift off the top chassis as shown in the figure with care without forcing or disconnecting the cables. ENGLISH To easy access to the internal circuitry, you must remove the controls panel. Unscrew the three screws (A), disconnect the three grounding jumpers (B), pull the controls panel toward you and raise it. To install the optional accessories it is not necessary to disconnect other jumpers of the controls panel, rest the panel temporarily on the keyboard. Note: Place two sheets of paper between controls panel and the flanks to avoid their scoring. Model - Modello Instructions / Istruzioni ENGLISH Disconnect the instrument from the mains. carefully turn the instrument over and unscrew the screws marked by the arrows. - Fix the mounting brakets [3] to the Hard Disk [6] by means of the four screw [4] and the four washers [5], fix the assembly to the threaded locations [B] by means of the four screws [4] and the four washers [5]. - Connect one end of the jumper [2] to the Hard Disk connector, starting from the extreme left end in order that 4 free pins remain to the right of the connector, and the other end to the CPU's CN8 connector [D]. NOTE: The optional Generalmusic Hard Disk is not supplied with this kit. Hard Disks are avalaible from special outlets with the same technical characteristics as the optional Generalmusic hard disk. If you mount the optional Generalmusic hard disk DO NOT FORMAT THE DEVICE, because it is supplied already formatted and filled with various styles, samples and songs. - Assemble the brackets (C) to the hard disk (B) using the screws (D) and their washers (E). Connect the HD (B) to CN8 to the CPU board (I) by means cable (H) as show in figure. IMPORTANT: if the hard disk is not supplied by Generalmisic, you may FORMAT it following the instructions enclosed in the owner's manual. [. . . ] - Assemble the brackets (C) to the hard disk (B) using the screws (D) and their washers (E). Connect the HD (B) to CN8 to the CPU board (I) by means cable (H) as show in figure. IMPORTANT: if the hard disk is not supplied by Generalmisic, you may FORMAT it following the instructions enclosed in the owner's manual. [. . . ]