User manual PEAVEY 112 PM

[. . . ] AVERTISSEMENT: Afin de prZvenir les risques de dZcharge Zlectrique ou de feu, nÕexposez pas cet appareil ^ la pluie ou ^ lÕhumiditZ. Avant dÕutiliser cet appareil, lisez les avertissements supplZmentaires situZs dans le guide. Dieses Symbol soll den Anwender vor unisolierten gefShrlichen Spannungen innerhalb des GehSuses warnen, die von Ausreichender StSrke sind, um einen elektrischen Schlag verursachen zu ksnnen. Dieses Symbol soll den Benutzer auf wichtige Instruktionen in der Bedienungsanleitung aufmerksam machen, die Handhabung und Wartung des Produkts betreffen. [. . . ] WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. Parallel Line Inputs These two jacks are provided to supply a single input signal to the 112 PM and to allow for daisychaining the signal to possibly another 112 PM or amp/monitor combination. Do not attempt to apply two different signals to the Parallel Line Inputs. Designed for a minimum impedance of 8 ohms, this output should be connected only to non-powered monitor enclosures. The Peavey 112M is the perfect extension monitor to use in this application. Four-Band Graphic EQ Use this Four-Band Graphic EQ to cut or boost your signal up to 12 dB at the designated frequency centers. This is especially useful for reducing low frequency rumble or feedback that often occurs on stage. Level The Level control adjusts the overall volume of the amplified signal. Therefore, by adjusting the Level control of the 112 PM you also adjust the level of any monitor(s) connected to the Full Range Output (5). 4 112 PMª Powered Floor Monitor Specifications Amplifier Specifications Rated Power (120V AC, 60 Hz): 75W into 8 ohms Input Impedance: Greater than 33K ohms Frequency Response: +0, -1 dB 30 Hz to 30K Hz Total Harmonic Distortion: Typically below . 1% Sensitivity: 1V RMS for full rated power output EQ: +, - 12 dB cut and boost Speaker System Specifications Frequency Response: 100 Hz to 17k Hz Sensitivity (1 Watt at 1 Meter): 96 dB SPL Weight: 40 lbs. Dimensions: 14. 63" H x 22. 50" W x 17. 75" D 37. 15 cm x 57. 15 cm x 45. 09 cm 112 PMª HOOK-UP DIAGRAM Second 112 PMª (optional) 112 PMª XR¨ 560 Mon. Line Output 112mª (optional) 5 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed, including the following: 1. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ] SAVE THESE INSTRUCTIONS! 6 PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTY Effective Date: July 1, 1998 What This Warranty Covers Your Peavey Warranty covers defects in material and workmanship in Peavey products purchased and serviced in the U. S. A. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. [. . . ]