User manual PARROT ZIKMU SOLO

[. . . ] 4 Caution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Removing the car stereo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installing the kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Car stereo with ISO connectors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Check that the orange wire is not connected to the constant +12V supply, as you could run down the vehicles battery. Note : On some vehicles, there is no ignition +12V on the vehicle's connectors. You must therefore connect the orange power supply wire to the fuse box or another ignition power source. Checking the wiring To perform the installation check, turn the ignition on then off once the Parrot MKi9200 is installed: the message "Goodbye!" must be displayed. If it is not the case, it is necessary to inverse the positions of the red and orange wires. Indeed, the red wire of the power cable must be connected to the permanent 12V, the orange wire to the 12V ignition and the black wire to the ground. This can be done simply by reversing both fuse holders located on the Parrot wiring. Installing the audio connectors Installing the music cable Connect the music cable to the electronic box and place the USB / iPod / Jack connectors into the glove box, the central console or the parcel tray depending on the configuration of your dashboard. Note : Use the provided protection cap to protect the connectors. Installing the music cable grommet system The music cable grommet system allows you to adjust the cable length while reducing its wear. Drill a 20 mm hole in your dashboard (glove compartment or parcel tray). > You can now connect your music cable to the bluebox. 7 Installing the individual components Installing the double microphone Selecting a location In order to get hi-quality conversations, we advise you to respect the following recommendations: Make sure the microphone is installed as close to the mouth of the user as possible. The best possible location for the microphone is near the rear-view mirror. The microphone needs to be pointed towards the user. D < 60 cm < 45° 8 Make sure the microphone is not exposed to the air stream from air vents. WARNING : The automatic synchronization is limited to 2 000 contacts for each paired phone. Sending contacts via Object Push If your phone doesnt support automatic synchronization, you can also send contacts from your mobile to the car kit via Object Push. Refer to your phones , , user guide for more information about sending contacts via Object Push. Deleting a contact Note : You can only delete contacts sent via Object Push. 1. Press the jog wheel and select Delete contact. Deleting all contacts Note : You can only delete contacts sent via Object Push. Press the jog wheel and select Phone > Delete all contacts. 15 Display parameters Modifying the display parameters Adjusting the brightness You can adapt the screen brightness of the Parrot MKi9200. Note : You can also adjust the brightness parameter by holding down the jog wheel for 2 seconds. Changing the display color 1. Press the jog wheel to confirm. Changing the wallpaper You can change the wallpaper of the Parrot MKi9200 by selecting one of the wallpapers proposed by default. Press the jog wheel and select Settings > Display > Wallpaper then use the jog wheel to choose the wallpaper you want to display. Press the jog wheel to validate. Customizing the wallpaper If you want to customize the Parrot MKi9200 wallpaper, you have to send a picture via Bluetooth. Make sure the Parrot MKi9200 is set so that it is visible by all Bluetooth devices. To do so, press the jog wheel and select Settings > Bluetooth > Visibility. Press the jog wheel then select Settings > Display > Wallpaper > Customize > Add. > « Waiting for a picture » is displayed on the Parrot MKi9200. [. . . ] Select the song and press the jog wheel. 27 Using the Parrot MKi9200 with a USB peripheral WARNING: If your Parrot MKi9200 is connected to an iPhone and an USB flash drive, the iPhone has priority: you can only browse through your iPhone content. 1. If the tags of your audio files are correctly defined, select one of the classification features (artist, album, songs, genres, playlist) and press the jog wheel. If the tags of your audio files are not defined, select Directories or Flat directories. buttons to navigate more easily through the content of your USB flash - Note : Use the drive. and 3. [. . . ]