User manual PARKSIDE PSS 260 ORBITAL SANDER

[. . . ] Please read the operating instructions below and the accompanying safety advice !By doing this you will be able to work in complete safety and produce better results. We hope you enjoy using your sander. FEATURES OF THE PSS 260 Clip Sanding sheet Base Air vents Dust bag adapter Paper dust bag TECHNICAL INFORMATION Nominal power: Low load speed: 260 W no 7, 000 ­ 11, 000/min Nominal voltage: 230 V ~ 50 Hz Dust extraction system: built-in extraction system / or with exterior suction device Weight: 2. 25 kg , Handle ON / OFF switch Adjuster wheel Continuous operation locking button Dust extraction nozzle (Fig. ) , , = accessories supplied Orbits: max. [. . . ] Lift both clips to open them to insert a new sanding sheet or change the sanding sheet for use on a different material. Push the sanding sheet under the open clip at one end and clamp it securely on the base by moving the clip down again. - The holes in the sanding sheet and the base must align for the dust to be extracted through the base. To determine which grade is suitable for your work, please read our recommendation in Tips and Tricks. DUST EXTRACTION · DUST EXTRACTION WITH PAPER DUST BAG Push the paper dust bag on to the adapter . Clip the dust bag with the adapter to the side of the sander. · DUST EXTRACTION WITH VACUUM CLEANER For dust extraction using a vacuum cleaner use the appropriate connector ­ see Figure . Attach the adapter to the end of the vacuum cleaner hose and clip it to the side of the equipment. 5 MAINTENANCE OF THE ORBITAL SANDER 1. For the best results do this straight after the work has been completed. Air vents must always be clear and clean. ADVICE ON WORKING METHODS, TIPS AND TRICKS You can use the PSS 260 orbital sander for effortless sanding even on large areas, see Fig. Move the orbital sander in parallel broad circles or in alternate longitudinal and transverse directions. This damages the sanding sheets and adversely affects sanding performance. The orbital sander works right into the corners because its housing is continuous with the edge of the sanding sheet, see Fig. · The integrated dust extraction system allows you to work cleanly overhead. Use the integrated dust extraction system or your vacuum cleaner wherever possible when sanding. · The choice of speed and grade of sanding sheet determines the sanding performance and therefore the results of your work. · Never use the same sanding sheet on different materials (e. g. ·* For metals we recommend 60 grade (steel) or 80 grade (aluminium) ­ with a medium to high speed. [. . . ] We reserve the right to make technical modifications in the course of further development. 6 STATEMENT OF CONFORMITY We, Kompernaß Handelsgesellschaft mbH, Burgstr. 21, D-44867 Bochum, Germany, hereby declare that this product conforms with the following EC regulations: EC low voltage regulations: Electromagnetic compatibility: Applicable harmonised standards: (98/37 EWG) (73/23/EEG), (93/68 EEG) (89/336 EEG), (92/31 EEG), (93/68 EEG) EN 50144-1:1998 EN 50144-2-4:1995 EN 55014-1:1993+A1 EN 61000-3-2:1995+A1+A2 EN 61000-3-3:1995 EN 55014-2:1997 Type: PSS 260 Bochum, 30. 06. 2002 Hans Kompernaß - Managing Director - 7 WARRANTY This piece of equipment is covered by a 36-month warranty as of the date of purchase. The equipment was produced with the greatest of care and underwent thorough testing before delivery. [. . . ]