User manual PARKSIDE PSS 250 A1 ORBITAL SANDER

[. . . ] KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE!THE TERM "ELECTRICAL TOOL" USED IN THE SAFETY ADVICE REFERS TO ELECTRICAL TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTERIES (WITHOUT A MAINS LEAD). Protection class: Noise and vibration data: Values determined in accordance with EN 60745 The sound pressure level (A-weighted) of the device is typically 82 dB(A). Evaluated acceleration, typical: Hand / arm vibration ah = 5, 5 m / s2 Uncertainty K = 1, 5 m / s2 WarNING!The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. [. . . ] Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. e) When working outdoors with an electrical power tool always use extension cables that are also approved for use outdoors. The use of an extension cable suitable for outdoor use reduces the risk of electric shock. f) Use a residual current device (rCD) for protection if operating the electrical power tool in a moist environment is unavoidable. Check that the electrical power tool is switched off before you connect it to the mains, pick it up or carry it. Accidents can happen if you carry the device with your finger on the ON / OFF switch or with the device switched on. d) remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury. By doing this you will be in a better position to control the device in unforeseen circumstances. Loose clothing, jewellery or long hair can become trapped in moving parts. g) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Ensure sufficient ventilation when working on plastics, paints, lacquers, etc. Do not soak materials or surfaces to be worked with liquids containing solvents. avoid sanding of lead-based paints or other materials that are hazardous to health. The appliance is designed for dry surface sanding of wood, plastic, metal and smoothing compounds as well as painted surfaces. Water entering an electrical device increases the risk of electric shock. always hold the appliance firmly with two hands while working (see also Fig. Never support your hands next to or in front of the device or on the surface being worked as there is a risk of injury in the event of slipping. always switch off the appliance and allow the sanding pad 9 to come to GB/IE/CY 9 General safety advice for electrical power tools / Operation a stop before setting down the oscillating sander. J always pull the power plug out of the socket for all work pauses, before any work on the appliance (e. g. Under certain conditions the sanding dust in the dust box (or in the vacuum's dust bag) may self-ignite, e. g. as a result of flying sparks generated when abrading 10 GB/IE/CY Operation metals or metal objects left in wood. [. . . ] If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. GB DES Ltd Units 14-15 Bilston Industrial Estate Oxford Street Bilston (Great Britain) WV14 7EG Tel. : 0870 / 787-6177 Fax: 0870 / 787-6168 e-mail: support. uk@kompernass. com IE Kompernaß Service Ireland Tel. : 1850 930 412 (0, 082 /Min. ) * Standard call rates apply. e-mail: support. ie@kompernass. com Q j Clean the appliance regularly, preferably j j j j Q always immediately after use. Remove adhering sanding dust with a brush. Service centre J WarNING! [. . . ]