User manual PARKSIDE PSG 50 A1 MANUAL 6

[. . . ] Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. [. . . ] D) Do not use the mains lead for any purpose for which it was not intended, e. To carry the device, to hang up the device or to pull the mains plug out of the mains socket. Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. Keep all the safety advice and instructions in a safe place for future reference!The term "electrical tool" used in the safety advice refers to electrical tools powered by mains electricity (by means of a mains lead) and electrical tools General safety advice for electrical power tools E) When working outdoors with an electrical power tool always use extension cables that are also approved for use outdoors. The use of an extension cable suitable for outdoor use reduces the risk of electric shock. f) Use a residual current device (RCD) for protection if operating the electrical power tool in a moist environment is unavoidable. Loose clothing, jewellery or long hair can become trapped in moving parts. G) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Careful handling and use of electrical power tools a) Do not overload the device. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. The use of tools or other accessories which are not recommended in the instructions may represent a risk of injury. In order to avoid injury, fire and health hazards: ½ Secure the work piece. There is a danger of injury from splintering materials flying into your eyes etc. During prolonged working with wood and particularly if materials are processed which produce dusts that are hazardous to the health. ½ Do not soak materials or areas which are to be worked on with solvent-containing liquids. ½ Material containing asbestos must not be processed with this device. ½ Under no circumstances should you prop up your hands next to or in front of the device or the area to be worked on. ½ Always route the cable towards the back away from the device. Before performing any work on the device, turn the device off and remove the mains plug. ½ During assembly and the final check of the blade you should wear appropriate protective gloves. [. . . ] This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. The warranty period will not be extended by repairs made unter warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. [. . . ]