User manual PARKSIDE PSBM 500 A1 IMPACT DRILL

[. . . ] Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. [. . . ] The use of an extension cable suitable for outdoor use reduces the risk of electric shock. f) Use a residual current device (RCD) for protection if operating the electrical power tool in a moist environment is unavoidable. Careful handling and use of electrical power tools a) Do not overload the device. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired. C) Pull the mains plug from the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. Do not allow the ventilation slots to become covered while the device is operating. Always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / poisonous dusts presents a danger to health for the tool operator and any persons in the vicinity. [. . . ] With the rotational direction switch 7 you can change the rotational direction of the electrical tool. NOTE: This is, however, not possible when the ON / OFF switch 6 is pressed down. Have your device repaired only by qualified specialist personnel using original manufacturer parts only. If the plug or mains lead needs to be replaced, always have Clockwise rotation: Push the rotational direction switch 7 to the right in order to drill and to screw in screws. [. . . ]