User manual PARKSIDE PMGS 12 A1 MODELLING AND ENGRAVING SET

[. . . ] Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Page Device-specific safety instructions for small drill KH3037 and mains adapter KH3037-1 . The following pictograms are used in these operating instructions / on the device: Read instruction manual!Risk of loss of life by electric shock from damaged mains lead or mains plug! [. . . ] With the aid of the combination wrench 23 , unscrew the screw from the mandrel 12 . Place the insertion tool you wish to have onto the screw between the two washers. With the aid of the combination wrench 23 , tighten the screw on the mandrel 12 . Switching on and off / Setting the speed range Never use the device for a purpose for which it was not intended or with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Switching on / Setting the speed range: Connect the plug 3 to the power supply unit 9 by inserting it into the plug-in device 7 provided for such purposes (see Fig. Connect the device to the power supply by inserting the mains plug into the socket. Advice on working with materials / Tools / Speed ranges Use the highest speed when working on steel or iron with the milling bits 20 . Use a short trial on a test piece to determine the optimum rotational speed range for working on zinc, zinc alloy, aluminium, copper and lead. Use the low speed range for working on plastics and low-melting point materials. Learn by practical experience which tools and settings are the best for the materials you work with. Setting the appropriate speed: Symbols on ON / OFF switch 1 OFF 5 7 10 17 20 Material to be worked on (Drill / grinder switched off) Plastics and low melting point materials Stone, Ceramics Softwood, metal Hardwood Steel Cleaning complex plastic housings or the area around a door lock E. Cleaning cutlery, jewellery, tools (The metal brush is softer than steel) Grinding work on stone, wood; fine work on hard materials such as ceramic or alloyed steel (see Figs. F, G) Cutting metal, plastic or wood Saw blade, Sawing steel, metal, wood or plastic (see Fig. If you use press too hard you run the risk of breaking the tool or damaging the workpiece. You will achieve the best results by operating the tool at a constant rotational speed and using a low contact pressure on the workpiece. Have your device repaired at the service centre or by qualified specialist personnel using original manufacturer parts only. If the plug or lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. Bär inte verktyget med fingret placerat på PÅ / AV-knappen eller se till att verktyget inte är anslutet till strömförsörjningen. Anslut verktyget till strömförsörjningen genom att ansluta nätkontakten till ett vägguttag. Safety advice relating specifically to this device, DIN EN 60745-2-3 Safety advice relating specifically to this device. Safety advice relating specifically to this device, DIN EN 60745-2-3 General safety advice for grinding, sanding (with sandpaper), wire brushing, polishing and disc-cutting: a) This electrical power tool is intended for use as a grinding, sanding, wirebrushing, and disc-cutting machine. [. . . ] Cutting discs are intended for removing material using the edge of the disc. Sideways forces on these abrasive consumables can cause them to break. D) Always use an undamaged mounting flange of the correct size and shape for your selected grinding disc. suitable flanges support the grinding disc and reduce the chance of it breaking. [. . . ]