User manual PARKSIDE PMFW 280 A1 MULTI-PURPOSE TOOL

[. . . ] Multi-Purpose Tool PMFW 280 A1 Plunge saw blade Metal saw blade Clamping screw and clamping plate (prefitted) Backing plate Introduction / General safety advice for electrical power tools Segment saw blade Scraping knife Sanding sheets Allen key Operating instructions Exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. [. . . ] If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Careful handling and use of electrical power tools a) Do not overload the device. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. General safety advice for electrical power tools Tool that can no longer be switched on and off is dangerous and must be repaired. Pull the mains plug from the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. A workpiece held in a clamp or vice is kept more securely in place than one held by your hand. Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. [. . . ] NOTE: The required oscillation speed depends on the material and the working conditions and can be determined by means of a practical test. Pull the mains plug out of the mains socket before you carry out any task on the electrical power tool. Clean the device frequently; for best results, do this immediately after you have finished using it. Use a dry cloth to clean the housing ­ under no circumstances use petrol, solvents or cleaning agents that attack plastic. [. . . ]