User manual PARKSIDE PLS 48 B1

[. . . ] C) Keep children and other people away while you are operating the electrical tool. To avoid danger to life from electric shock: a) The mains plug on the device must match the mains sock et. Do not use an adapter plug with devices fitted with a protec tive earth. [. . . ] Many accidents have their origins in poorly maintained electrical tools. Safety advice / Before first use The use of attachments or accessories other than those recommended here could lead to you suffering an injury. Remove a soldering tip only when the device has been switched off and the soldering tip has cooled. Thinly coat with solder, the soldering tip 7 before using the soldering station for the first time and before using a new soldering tip. To do this follow these steps: Insert the mains plug into a mains socket and press the ON / OFF switch 2 into position "I". Turn the temperature regulator 6 to 3 and allow a little solder to flow and deposit a thin continuous film over the surface of the soldering tip. Using the product Switching on / off and setting the temperature Switching on and setting the temperature: Insert the mains plug into a mains socket and press the ON / OFF switch 2 into position "I". Turn the temperature control 6 to set the temperature you wish to have. Problems will occur during soldering if an unsuitable solder wire used. the right soldering temperature must be achieved to produce perfect soldering. If the temperature is too low the solder does not flow enough and causes contamination of the solder at the joint, a so-called "cold joint". At too high a temperature, the flux (flowing aid) burns and the solder does not flow. 100 °C ­ warming up stage and for solder with a low melting point Setting 2 = 200 °C melting point of most common soft solders Setting 3 = 300 °C normal operating temperature, e. For desoldering large soldered joints Switching off: Note: After use always replace the soldering pencil 1 into the holder. If the device is not being used, pull the mains lead out of the mains socket. The hot soldering tip 7 must never be placed in contact with a dry solder sponge 5 , otherwise the solder sponge may be damaged. [. . . ] The warranty period will not be extended by repairs made unter warranty. Fects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. [. . . ]