User manual PARKSIDE PHS 160 A1 MANUAL 7

[. . . ] The A-weighted noise level of the electrical power tool are typically: Sound pressure level: 76 dB(A) Sound power level: 90 dB(A) Uncertainty K: 3 dB A) Keep your working area clean and well lit. B) Do not work with the device in potentially explosive environments in which there are inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes. C) Keep children and other people away while you are operating the electrical tool. [. . . ] Accidents can happen if you carry the device with your finger on the ON / OFF switch or with the device switched on. D) Remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury. By doing this you will be in a better position to control the device in unforeseen circumstances. Loose clothing, jewellery or long hair can become trapped in moving parts. G) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. personal safety A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. Always use an electrical power tool that is intended for the task you are undertaking. Never use the device for a purpose for which it was not intended nor with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Switch the device off and allow it to come to a standstill before you put it down. Make sure that the device is switched off before you connect it to the mains supply. Always switch on the delta sander before bringing it into contact with the workpiece material. Switching off the device: Move the ON / OFF switch 8 upwards into the "OFF" position. Removal: Press the release button 5 of the dust extraction box for internal vacuum extraction 4 and withdraw it towards the rear of the device. There is the danger of fire when working with electrical devices that have a dust box or can be connected to a vacuum cleaner. Under certain conditions the wood dust in the dust extraction bag (or in the vacuum`s dust bag) may ignite, e. As a result of flying sparks generated when abrading metals or metal objects left in wood. This can happen particularly if the wood dust is mixed with paint residue or other chemicals and the abraded particles are hot from prolonged abrasion. [. . . ] After sanding the workpiece, lift the device from the workpiece before switching it off. Have your device repaired only by qualified specialist personnel using original manufacturer parts only. If the plug or mains ½ lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. It has been carefully produced and meti-culously checked before delivery. [. . . ]