User manual PARKSIDE PHLG 600

[. . . ] 600 l / min. MAKE SURE THAT YOU KEEP THESE INSTRUCTIONS AND SAFETY ADVICE IN A SAFE PLACE. V~ Voltage Nominal voltage: Power consumption: Air volumes: Temperatures (Jet outlet nozzle): 1. b) Do not work with the device in potentially explosive environments in which there are inflammable liquids, gases or dusts. Electrical power tools create sparks, which can ignite dusts or fumes. c) Keep children and other people away while you are operating the electrical tool. [. . . ] Make sure that the switch is in the "OFF" position before you insert the mains plug into the mains socket. Accidents can happen if you carry the device with your finger on the switch or you have already switched the device on before you connect it to the mains. d) remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury. By doing this you will be in a better position to control the device, especially in unforeseen circumstances. Loose clothing, jewellery or long hair can become trapped in moving parts. g) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. in accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. J General safety advice Do not work in the vicinity of easily ignitable gases or materials. Always place your heat gun down on its end, with the nozzle pointing upwards. When taking a break from your work, before carrying out any tasks on the device itself (e. g. changing the nozzle) or when you are not using the device, always pull the mains plug out of the mains socket. Maintain a distance between the jet outlet nozzle and the workpiece or the surface being heated. The heat produced could reach to inflammable articles located out of the visible area. Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Children must never be allowed to play with the device. J J J J J Safety advice relating specifically to this device ATTenTIOn!To avoid the danger of injury, burning and dangers to your health: J If danger arises, pull the mains plug immediately out of the mains socket. [. . . ] j Use the reducing nozzle 8 for heat-shrinkable sleeves and film. Information Service Q Details of the Service Centre responsible for your region are shown in the warranty documents. J Have your device repaired only by qualified specialist personnel using original manufacturer parts only. If the plug or mains lead needs to be replaced, always have the replacement carried out by the manufacturer or its service centre. This will ensure that your device remains safe to use. The Cold-Air Setting I is suitable for: - Drying varnish / paint - Cooling of heated workpieces - Cooling the appliance before storage / changing the nozzles removing the heat shield: CAUTIOn! [. . . ]