User manual PARKSIDE PHKS 1400 CIRCULAR SAW

[. . . ] By doing this you will be able to work in complete safety and achieve better results. ON - OFF switch Safety switch Electronic speed control Adjustable depth stop Sawdust outlet Bevel cutting capacity with angle gauge Guide plate Parallel guide fence with millimetre scale Retractable guard Tips for use Depth of cut gauge Wing nut on parallel guide fence Power consumption: No load speed: Blade: Cutting depth at 90°: Cutting depth at 45°: 1400 W 1800 - 5200 rpm 210 x 30 x 1. 1 kg The A weighted noise level of the equipment is typically: Sound pressure level: 107. To be read in conjunction with the advice in the accompanying booklet on safety. [. . . ] Make sure that the diameter, thickness and other saw blade parameters are suitable for use in the circular saw. Make sure the saw blade speed rating is suitable for the spindle rotation speed of the circular saw. The distance between the reamer and the saw teeth is to be set to 5 mm maximum. The distance between the point of the reamer and the deepest point of the saw blade is to be 5 mm maximum. When you switch off the saw, do not use any additional means of stopping the saw blade. If you wish to make an alteration to this angle use the adjustment screw. Ⲡ, set the required angle on the scale and tighten the wing nuts again. Note: We recommend that the depth of cut is set if possible 5 mm greater than the material thickness. Release the wing nut on the depth stop ¿, set the required depth of cut on the scale and tighten the wing nut again. To switch the saw motor on, first press the safety switch and then (keeping the safety switch pressed) press the on/off switch ³. Switch on the motor as described in the section "On/off switch" and then set the front edge of the guide plate ¶ down on the material. Align the circular saw with the parallel guide º or with a drawn cutting line. Hold the circular saw with both hands on the handles and saw using moderate force. Using the following advisory settings as a guide, set the rpm on the electronic control wheel » to an appropriate value. Turn the wheel until the required rpm setting is opposite the arrow marking ( ). (1 = lowest rpm to 4 = highest rpm): Material Hard- and softwoods (natural wood) with & across grain Chipboard, hardboard Chipboard Veneered plywood, plywood Coated and veneered board PVC board Acrylic sheet, Plexiglas Aluminium sheet Aluminium sections Plasterboard Rock wool board Cement bound woodwool board Thickness to max. Caution: The distance between the reamer and the saw blade is not to be more than 5 mm. Release the wing nut on the depth stop and swing the saw to meet the stop. CAUTION / IMPORTANT: After plunging, the reamer must be refitted before further use. The distance between the reamer and the saw blade teeth is to be set to 5 mm max. [. . . ] This has the additional advantage of the cut line being more easily seen on the tape than on a smooth surface. An even more effective way of avoiding the surface pulling off at the cut edge is to attach a piece of thin wood which is then sawn at the same time. The PHKS 1400 circular saw is equipped with INTELLIGENT POWER CONTROL. This automatic power control ensures that within a certain oscillation range the output from the jigsaw remains constant even when cutting harder and more resistant materials. [. . . ]