User manual PARKSIDE PGG 15 A1 MANUAL 6

[. . . ] Introduction / General safety advice for electrical power tools Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circumstances. Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account the intervening periods of time when the device is switched off or is running but is not actually in use. This can result in a much lower vibration load over the whole of the period of working. [. . . ] D) Do not use the mains lead for any purpose for which it was not intended, e. To carry the device, to hang up the device or to pull the mains plug out of the mains socket. Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. E) When working outdoors with an electrical power tool always use extension cables that are also approved General safety advice for electrical power tools for use outdoors. The use of an extension cable suitable for outdoor use reduces the risk of electric shock. Use a residual current device (RCD) for protection if operating the electrical power tool in a moist environment is unavoidable. A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. Check that the electrical power tool is switched off before you connect it to the mains, pick it up or carry it. Never use the device for a purpose for which it was not intended or with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Turn the switch for the number of strokes 2 in the + direction to increase the penetration depth. Turn the switch for the number of strokes 2 in the ­ direction to decrease the penetration depth. Switch the device off before performing any tasks on the device and pull the mains plug out of the mains socket. Replace the engraving point 5 as soon as it becomes too worn and no longer provides the desired engraving performance. Turn the engraving point holder 6 anticlockwise until the engraving point 5 is released. Insert a new engraving point 5 and turn the engraving point holder 6 clockwise to lock the engraving point in position. Note: Engraving points are also available from specialist dealers or DIY shops. Advice on use You can use the mini-engraver to produce creative, individual engravings. For example, you can use it to place identifying marks on your valuables. [. . . ] The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. In the event of a warranty claim, please make contact by telephone with our Service Department. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. [. . . ]