User manual PARKSIDE PFSPS 150

[. . . ] C Spray Gun D X X E Kompernaß Handelsgesellschaft mbH Burgstr. 21 · D-44867 Bochum (Germany) Preparation of material to be sprayed PFSPS 150 Spray Gun Dear Customer, it is recommended to familiarise yourself with the functions of the spray gun before using it and to study the operating instructions carefully, including the safety information . [. . . ] 2. ) Do not switch the spray gun on/off over the spraying area, but start and end spraying about 10 cm outside the spraying area. ­ Move the spray gun parallel with the surface - do not move from side to side. ­ The paint coats need to dry before the next coat is applied crosswise -- see Fig. 4. ) Do not empty the tank completely as this will produce drips ! Noise and vibration measured according to EN 50144-1:1998, EN 50144-2-7:2000 The A-rated sound pressure level of the device is typically 93, 9 dB(A). The hand vibration is typically lower than 2. 5M/s2 PFSPS features 1. Spring Safety information relating to the use of the spray gun · · · · · · · · · Read the information in the enclosed "General safety information" booklet Inhaling the spray is dangerous to health Wear a protective mask !When working in closed rooms, ensure good ventilation Explosion hazard !Do not spray any flammable or explosive liquids Never aim the spray jet at people or animals The spray gun must not be used in an environment where gases are present or can develop Maintenance and cleaning ­ General information 1. ) 2. ) 3. ) 4. ) Disconnect the mains plug, also when working on the gun and when the gun is not in use. Spray sewing machine oil through the spray gun after cleaning for protection against rust. Never immerse the spray gun in cleaning agent. Maintenance and cleaning ­ Special information 1. ) 2. ) 3. ) 4. ) 5. ) 6. ) Disconnect the mains plug, also when working on the gun and when the gun is not in use. [. . . ] · Spraying in the area of lakes, rivers or canals or surrounding areas (catchment area) is therefore forbidden. · When purchasing paints, lacquers and varnishes, it must be ensured that these are environmentally compatible. ¹ ¸ GB 4 GB 5 [. . . ]