User manual PARKSIDE PEC 200 SE

[. . . ] The manufacturer declines to accept responsibility for damage(s) arising out of usage contrary to the instructions specified below. The appliance is not intended for commercial application. Q Fittings ON / OFF switch / Stroke rate preselector Tool arrestor Tool receptor Tool attachment Knife / Scraper attachment (offset) Knife / Scraper attachment (straight) Spatula attachment Chisel attachment Intended Utilisation 1 2 3 4 5 6 7 8 The appliance is suitable for the removal and abrasion of coverings such as carpets, felts, cork sheets and plaster on small areas. It is also intended for removing residues of adhesives, paints and fillers, for the smoothing of coarse surfaces as well as for carvings on soft woods. Any other use of, and 6 GB/IE/CY Q Items supplied 1 Power scraper 1 Knife / Scraper attachment (offset) Introduction / General safety advice for electrical power tools 1 1 1 1 Q Knife / Scraper attachment (straight) Spatula attachment Chisel attachment Operating manual General safety advice for electrical power tools WarNING! [. . . ] d) remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury. By doing this you will be in a better position to control the device in unforeseen circumstances. Loose clothing, jewellery or long hair can become trapped in moving parts. g) If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Personal safety a) remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. 8 GB/IE/CY 4. Careful handling and use of electrical power tools a) Do not overload the device. always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. An electrical power tool that can no longer be switched on and off is dangerous and must be repaired. c) Pull the mains plug out of the socket before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent you from unintentionally starting the device. General safety advice for electrical power tools / Before taking tool into use d) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. in accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. [. . . ] It has been carefully produced and meti-culously checked before delivery. Contact your service centre by telephone in case of questions pertaining to the warranty. This warranty applies only to the initial purchaser and is non-transferable. The warranty covers only material or manufacturing faults, not normal wear or damage to fragile parts such as switches or rechargeable batteries. [. . . ]