User manual PARKSIDE PEBH 780 ROTARY PERCUSSION DRILL

[. . . ] By doing this you will be able to work in complete safety and produce better results. 800 /min 24 mm in concrete 13 mm in steel 30 mm in wood II 3, 3 kg Sound pressure level: Sound power level: Vibration: Lp = 099, 6 dB(A) Lw = 112, 6 dB(A) 8, 5 m/s2 To be read in conjunction with the advice in the accompanying booklet on safety before using for the first time. To avoid causing damage and danger to life, before starting work check the surface you are about to drill (e. [. . . ] For short periods of operation choose the instanta neous mode and for longer periods of operation choose the continuous mode. This is how to operate the drill at your chosen setting: INSTANTANEOUS OPERATION ON: Press ON/OFF trigger INSTANTANEOUS OPERATION OFF: Release ON/OFF trigger CONTINUOUS OPERATION ON: CONTINUOUS OPERATION ON: Press ON/OFF Press ON/OFF trigger and lock in position with the trigger lock button trigger once more and release. Before inserting the tool, lightly grease the chuck and clean if necessary. to insert pull the locking/unlocking cap backwards and ins ert the tool. You should be able to hear clearly the tool engaging if it has been inserted correctly. To remove the tool, pull the locking/unlocking cap backwards again and remove the tool. You should be able to hear clearly the additional chuck engaging if it has been inserted correctly. To remove the additional chuck, pull the locking/unlocking cap backwards again and remove the additional chuck. Only use / set the function selector after the motor has reached a standstill. You can set the function selector to the symbol appropriate to the area of use. Only use / set the forward / reverse selector after the motor has reached a standstill. Note: The maximum speed for heavy work is only available in forward mode. Only use / set the speed control wheel after the motor has reached a standstill. You can use the speed control wheel to preselect the operating speed to the exact value appropriate to your work. In addition, it allows you to avoid the drill bit slip ping and breaking material out around the hole whilst drilling. Note: If you select a low speed, this means the ON / OFF trigger will only press in a limited amount (as a result of the reduced speed pre selected). [. . . ] For the best results do this straight after the work has been completed. Do not use petrol, solvents or cleaners that might attack the plastic. Further practical tips for power tools can be found in the accompanying booklet on safety advice. [. . . ]