User manual PARKSIDE PDS 290 A1

[. . . ] Any other use or modification to the device shall be considered as improper use and could give rise to considerable dangers. We will not accept liability for loss or damage arising from improper use. Introduction / General safety advice for electrical power tools Noise and vibration data: Measured values for noise are determined in accordance with EN 60745. The A-weighted noise level of the electrical power tool are typically: Sound pressure level: 78 dB(A) Sound power level: 89 dB(A) Uncertainty K: 3 dB TOOLS POWERED BY MAINS ELECTRICITY (BY MEANS OF A MAINS LEAD) AND ELECTRICAL TOOLS POWERED BY RECHARGEABLE BATTERIES (WITHOUT A MAINS LEAD). [. . . ] D) When not in use always ensure that electrical power tools are kept out of reach of children. Do not let anyone use the device if he or she is not familiar with it or has not read the instructions and advice. Electrical power tools are dangerous when they are used by inexperienced people. Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Have damaged parts repaired before you use the A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. The wearing of personal protective equipment such as dust masks, non-slip safety shoes, safety helmets or ear protectors, appropriate to the type of electrical power tool used and work undertaken, reduces the risk of injury. Check that the electrical power tool is switched off before you connect it to the mains, pick it up or carry it. Accidents can happen if you carry the device with your finger on the ON / OFF switch or with the device switched on. D) Remove any setting tools or spanners before you switch the device on. A tool or spanner left attached to a rotating part of a device can lead to injury. General safety advice for electrical power tools / Preparing for use device. Many accidents have their origins in poorly maintained electrical power tools. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. ½ Do not soak the materials or the surface you ½ ½ ½ ½ ½ ½ Are about to work on with liquids containing solvents. Avoid sanding paints containing lead or other substances hazardous to health. Never use the device for a purpose for which it was not intended nor with non-original parts / accessories. The use of tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Switch the device off and allow it to come to a standstill before you put it down. [. . . ] Always pull the mains plug out of the socket before doing any work on the device. Turn the backing plate 6 of the delta sander in 60° steps until it engages in the desired position (see Fig. Sanding and surfaces: The shape of the delta sander allows you to sand workpieces even in their difficult to access places, corners and edges (see Fig. Always use sanding sheets with grades that are suitable for the particular surface you are sanding. [. . . ]