User manual PARKSIDE PDS 200 A

[. . . ] When not being used electrical power tools should be stored in dry conditions in a high or enclosed place, out of reach of children. By keeping within the specified working range of the tool you will work more safely and achieve a better result. Do not use an electrical power tool for purposes for which it was not intended. For example, do not use a hand operated circular saw for trimming tree branches or cutting logs. [. . . ] ½ Do not operate the device if it is damp and do not use it in a damp environment. ½ If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. 18. ½ 8 General safety advice / Before use If using an extension lead, always use one that is approved for outdoor use. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the work area. Wear protective glasses, hearing protection, dust protection mask and protective gloves. When grinding for longer periods, stop grinding from time to time and allow the workpiece to cool before continuing. Do not operate the device for continuous periods exceeding 30 minutes. The double grinding machine is intended for dry grinding of the surfaces of metal objects. Only use grinding wheels with details that correspond with those given on the device rating plate. The circumferential speed should be equal to or greater than the value given on the device rating plate. Adjust the eye guard mounts 2 (spark deflectors) and the eye guards 3 periodically so that wear on the grinding wheels can be evened out. Switching off: Press the ON / OFF switch 9 into the "0" position to switch the device off. © Positioning the workpiece / tool rests and eye guard mounts © Grinding a workpiece To ensure safe working, the workpiece / tool rests 5 , the eye guards 3 and the eye guard mounts 2 must be correctly positioned. Check and correct the settings at frequent intervals to ensure even wear on the grinding wheels 4 . Adjusting the workpiece / tool rests: 1) To adjust the setting, first loosen the adjuster screw 6 . 2) Bring the workpiece / tool rest 5 close up to the grinding wheel 4 , the distance between the grinding wheel 4 and the workpiece / tool rest 5 must be no more than 2 mm. 3) Retighten the adjuster screw 6 and check using your hand that the grinding wheel 4 movement is true and free. NOTE: Use the fine grinding wheel for precise grinding tasks (grade "A80M"). NOTE: Use the coarse grinding wheel for rough grinding tasks (grade "A36M"). To grind metal tools or metal items, place the workpiece on the workpiece / tool rest 5 and slowly bring it up to the grinding wheel 4 . When grinding always use the circumferential end face (not the sides) of the grinding wheel only (See Figures D, E, F). © Replacing a grinding wheel Adjusting the eye guard mounts: 1) To adjust the setting, first loosen the fastening screw 14 . [. . . ] If this product has been subjected to improper or inappropriate handling, abuse, or interventions not carried out by one of our authorised sales and service outlets, the warranty will be considered void. This warranty does not affect your statutory rights. © Maintenance and cleaning WARNING!Before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. For best results, clean the double grinding machine immediately after you have finished using it. [. . . ]