User manual PARKSIDE PDOS 200 A1 MANUAL 7

[. . . ] Power input: 200 W No load speed: n0 2950 min-1 Grinding wheel diameter: 150 mm Grinding wheel width: 20 mm Grinding wheel bore: 20 mm Circumferential speed max. In order to protect yourself from the danger of electric shock, injury or fire when using electrical power tools, please observe the following basic safety precautions. Read all these requirements before you use the electrical power tool, and keep the safety advice in a safe place. ½ Do not use electrical power tools in moist or wet surroundings. [. . . ] Have your electrical power tool repaired at an electrical equipment repair specialist. ½ This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. ½ Do not touch the mains lead if it becomes damaged or cut through while you are using the device. Pull the plug out of the mains socket immediately and have the device repaired by a suitably qualified person or at your service centre. Do not operate the device if it is damp and do not use it in a damp environment. If you use the device outdoors, always connect it through a residual current device (RCD) with a maximum trip current of 30 mA. General safety advice / Before use If using an extension lead, always use one that is approved for outdoor use. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. Working with harmful / noxious dusts represents a risk to the health of the person operating the device and to anyone near the work area. Wear protective glasses, hearing protection, dust protection mask and protective gloves. When grinding for longer periods, stop grinding from time to time and allow the workpiece to cool before continuing. Only use grinding wheels with details that correspond with those given on the device rating plate. The circumferential speed should be equal to or greater than the value given on the device rating plate. Adjust the eye guard mounts 2 (spark deflectors) and the eye guards 3 periodically so that wear on the grinding wheels can be evened out. Before you insert the mains plug into the socket, always check that the device is switched off. ½ Always switch the device on before bringing the workpiece into contact with the grinding wheel. After grinding, lift off the workpiece before switching the device off. After you have finished grinding metal, allow the grinding wheel(s) to come to a standstill. When taking a break from your work, before carrying out any tasks on the device itself and when you are not using the device, always pull the mains plug out of the mains socket. [. . . ] Preparing for first use Switching on and off Switching on: Press the ON / OFF switch 9 into the "1" position to switch the device on and run it at a constant speed. 1) Take off the outer part of the wheel guard cover 7 by unscrewing the 3 threaded fixings (see Figs. 2) Release the nut 13 by preventing the nut on the opposite side from rotating and then remove the outside flange 12 . This ensures that the nuts 13 can only be screwed off in the direction of rotation of the spindle. [. . . ]