User manual PARKSIDE PDFP 500 A1 AIR PAINT SPRAY GUN

[. . . ] Keep children and other people away while you are operating the device. Disconnect the device from the compressed air source before carrying out any repair or maintenance work, during interruptions to operations and before transporting the device. When removing the hose coupling, hold the hose tightly in your hand to avoid injury caused by the hose shooting backwards. [. . . ] The use of a special nozzle insert with the appropriate nozzle head reduces the probability of a high-pressure jet penetrating the skin and injecting toxins into the body. Operate the product only with cleaned, condensate- and oil-free compressed air and never exceed the maximum working air pressure at the device of 3 bar. The compressed air source must be fitted with a (filter) / pressure reducer so that the air pressure can be regulated. In order to operate this device you require a flexible compressed air hose with quick-release coupling and an appropriate source of compressed air. Observe the operating and safety instructions of the compressed air source and any special instructions concerning paint preparation. If the working pressure is too low on the other hand, the paint material is not sufficiently atomised. Use the filter pressure reducer of the compressed air source to set the working pressure to 3 bar. Adjusting the round jet: Use the round jet, for example, for small surfaces, corners and edges. The nozzle head 9 can be continuously adjusted vertically and horizontally by turning to the desired position. Working Instructions: - When working with the device you should open the vent 1 . - When diluting the material, make sure that the spraying material and the dilution are suitable for one another. If an incorrect dilution is used, lumps may form and clog the gun as a result. - Fill the spraying material into the flow cup 3 and screw the lid 2 on tight. - Always hold the paint spray gun at the same distance from the object. - Do not turn the device on / off when it is over the spraying surface, but start and end the spraying process approximately 10 cm outside of the spraying area. Note: The front locking screw is used to limit the adjustment range of the stroke stop screw 4 . In order to do this, open the air volume Increasing the air quantity: Note: Increasing the amount of air is generally advisable when the degree of atomization is too coarse. Reducing the air quantity: Note: Reducing the amount of air is generally advisable when the paint spray is too strong. [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Consider their environmental compatibility when buying paints, varnishes etc. [. . . ]