User manual PARKSIDE PDEXS 150 A1

[. . . ] Ensure that the compressed air supply hose cannot wave around in an uncontrolled manner. self-adhesive sanding sheets must be attached concentrically on to the backing plate. Release the trigger / operator`s lever if there is an interruption in the mains power supply. use only the lubricant (pneumatic oil) recommended by the manufacturer. [. . . ] Avoid sanding lead-based paints or other materials that are hazardous to health. The appliance must always be kept clean, dry and free of oil or grease. A workpiece held in a clamp or vice is kept more securely in place than one held by your hand. Never support yourself by placing your hands near or in front of the device or the workpiece surface. On task completion, lift the appliance from the work piece and then switch it off. Permit the switched off appliance to come to a complete standstill before putting it down. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. Before use / Preparing for use before use Selecting the grinding Disc Metal Removal and Surface: The rate of metal removal and the surface quality are determined by the grain size of the grinding disc. Lease note that corresponding grinding discs with different grain sizes should be used for processing different materials. You may ensure this in any of the following ways: Connect a service unit with an oiler to the compressor. Install a line oiler in the compressed air line or at the compressed air device. 3­5 drops of pneumatic oil by hand into the plug nipple 3 every 15 minutes of operation. The air sander is fitted with a hook and loop fastening, which allows for quick and easy replacement of sanding discs. Lift the grinding disc at the side and pull it off from the backing pad 6 in order to remove it. Note: Before securing a new sanding sheet, remove all dust and dirt from the sander plate 6 . Note: The air sander must be operated using cleaned and condensate-free compressed air only and its maximum allowable working pressure of 6. Note: The compressed air source must be fitted with a (filter) pressure reducer so that the air pressure can be regulated. Using the internal vacuum extraction with dust collection device (see Fig. b): Push the exhaust air hose 9 fully on to the connection for dust extraction 2 . Put the opening of the dust bag 10 over the free end of the exhaust air hose 9 and fasten the dust bag 10 firmly in position. Note: Always switch on the air sander before bringing it into contact with the workpiece material. After you finish work, disconnect the device from the compressed air source. [. . . ] In the event of a warranty claim, please make contact by telephone with our Service Department. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]