User manual PARKSIDE PBSG 95 A1

[. . . ] The manufacturer will not accept liability for loss or damage arising from improper use. 22 GB 1 drill sharpening machine PBSG 95 A1 1 carrying case 16 titanium-coated HSS drills (see Fig. E) 2 spare sharpening stones 1 set of operating instructions Q Technical  data Dimensions:  128 x 173 x 202 mm (w x h x d) Weight: 950 g Introduction / General safety advice Nominal voltage: Nominal output: Nominal rotation speed: For drill bits of diameter: Protection class: 230–240 V~ 50 Hz 95 W 1350 rpm 3–10 mm II /   not allow other people, in particDo ular children, to touch the electrical power tool or the mains lead.  hen not being used electrical power tools W should be stored in dry conditions in a high or enclosed place, out of reach of children. [. . . ]  he use of inserted tools and accessories other T than those recommended by the manufacturer could lead to you being injured.  ave your electrical power tool H repaired at an electrical equipment repair specialist.  his electrical power tool complies with the T relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. Device-specific safety instructions for drill sharpeners  ake sure that the device is switched M off before inserting the mains plug into the socket.  lways pull the mains plug out before A carry out cleaning or maintenance work.  he ventilation openings 10 of the moT tor unit must always be kept clear.  hen carrying out work on the device W as well as transporting or storing it, move the ON / OFF switch 4 to the “0” position (off) in order to prevent it switching itself on by accident. That is why you General safety advice / Use  should always make sure that no-one is at risk from them and that no combustible materials are located in the proximity of the area of work. Use the ON / OFF switch 4 to switch the grinder off in the event of a power failure or when pulling out the mains plug. This prevents the grinder restarting by accident, which could cause injury to you.  ever operate the grinder if the power N cable or mains plug is damaged.  rinding stones must be carefully G stored and handled according to the manufacturer’s instructions.  ake sure that the grinding tools are M appropriate in line with the instructions of the manufacturer.  heck the grinding stone before using C it; do not use any broken, cracked or otherwise damaged goods. Make sure that a grinding tool is correct ly fitted and fastened before using it. Place the grinder in a safe place and allow it to run idly for 30 seconds. Stop it immediately if considerable oscillations occur or if defects are observed. Q Original  accessories /  Attachments  se only the accessories and attachments U detailed in the operating instructions. The use of inserted tools or accessories other than those recommended in the operating instructions could lead to you suffering an injury. [. . . ] Q Maintenance   o clean the casing, use a dry cloth; on no T account should you use any petrol, solvents or cleaning agents. Any  repairs or replacements should only be carried out by the service centre or an electrician. Q Service  Have your device repaired  the service centre or by qualified at specialist personnel using original manufacturer parts only. If the plug or lead needs  be replaced, always have the to replacement carried out by the manufacturer or its service centre. [. . . ]