User manual PARKSIDE PBSG 55 A1

[. . . ] ½ By keeping within the specified working range of the tool you will work more safely and achieve a better result. ½ Do not use an electrical power tool for purposes for which it was not intended. For example, do not use a hand operated circular saw for trimming tree branches or cutting logs. ½ We recommend that you wear anti-slip footwear when working outdoors. [. . . ] Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. ½ ½ Make sure that the device is switched off before inserting the mains plug into the socket. Always pull the mains plug out before carry out cleaning or maintenance work. The ventilation openings 10 of the motor unit must always be kept clear. When carrying out work on the device as well as transporting or storing it, move the ON / OFF switch 4 to the "0" position (off) in order to prevent it switching itself on by accident. That is why you should always make sure that no-one is at risk from them and that no combustible materials are located in the proximity of the area of work. Use the ON / OFF switch 4 to switch the grinder off in the event of a power failure or when pulling This prevents the grinder restarting by accident, which could cause injury to you. Never operate the grinder if the power cable or mains plug is damaged. Grinding stones must be carefully stored and handled according to the manufacturer's instructions. Make sure that the grinding tools are appropriate in line with the instructions of the manufacturer. Check the grinding stone before using it; do not use any broken, cracked or otherwise damaged goods. Make sure that a grinding tool is correctly fitted and fastened before using it. Place the grinder in a safe place and allow it to run idly for 30 seconds. Stop it immediately if considerable oscillations occur or if defects are observed. Turn the rotary switch 1 in the UP direction until you hear a grinding noise. NOTE: The rotary switch 1 controls the position of the sharpening stone in the sharpening head housing and therefore the pressure of the sharpening stone against the drill. the further you turn the rotary switch 1 in the UP direction , the greater the pressure. Turn the drill under slight pressure loosely and quickly to and fro between the left and right stops about 10 times (with small drills about 5 times). Pull the drill out, turn it through 180° (horizontally) and insert it again until it meets the sharpening stone. If necessary repeat whole process until both cutting edges of the drill are sharp. control the grinding operation so that the angle between the main and transverse cutting edges for a standard drill is 130°. Both cutting edges (b) must have the same angle to the drill axis (a) and be the same length so that the drill runs concentrically (see following figures). [. . . ] Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Apart from replacing the sharpening stone, the drill sharpener is maintenance-free. To clean the casing, use a dry cloth; on no account should you use any petrol, solvents or cleaning agents. [. . . ]