User manual PARKSIDE PBSG 1

[. . . ] Read all these requirements before you use the electrical power tool, and keep the safety advice in a safe place. ½ Do not use electrical power tools in moist or wet surroundings. ½ Do not use electrical power tools in areas where there is risk of fire or explosion. ½ Avoid touching earthed objects such as pipes, heating radiators, ovens or refrigerators with parts of your body. [. . . ] ½ Never use an electrical power tool that cannot be switched on and off properly. ½ The use of inserted tools and accessories other than those recommended by the manufacturer could lead to you being injured. Have your electrical power tool repaired at an electrical equipment repair specialist. ½ This electrical power tool complies with the relevant safety regulations. Repairs may only be carried out by a specialist electrical repair centre using original spare parts, otherwise injury could occur to the user. Always pull the mains plug out before carry out cleaning or maintenance work. The ventilation openings 2 of the motor unit 3 must always be kept clear. When carrying out work on the device as well as transporting or storing it, move the ON / OFF switch 4 to the "0" position (off) in order to prevent it switching itself on by accident. Should always make sure that no-one is at risk from them and that no combustible materials are located in the proximity of the area of work. Use the ON/OFF switch 4 to switch the grinder off in the event of a power failure or when pulling out the mains plug. This prevents the grinder restarting by accident, which could cause injury to you. Never operate the grinder if the power cable or mains plug is damaged. Grinding stones must be carefully stored and handled according to the manufacturer's instructions. Make sure that the grinding tools are appropriate in line with the instructions of the manufacturer. Check the grinding stone before using it; do not use any broken, cracked or otherwise damaged goods. Make sure that a grinding tool is correctly fitted and fastened before using it. Place the grinder in a safe place and allow it to run idly for 30 seconds. Stop it immediately if considerable oscillations occur or if defects are observed. Pull the drill out, turn it through 180° (horizontally) and insert it again until it meets the sharpening stone. If necessary repeat whole process until both cutting edges of the drill are sharp. Press the ON / OFF switch 4 into position "0" to switch off the device. Always pull the mains plug is out of the socket before doing any work on the device. [. . . ] Apart from replacing the sharpening stone, drill sharpener is maintenance-free. To clean the casing, use a dry cloth; on no account should you use any petrol, solvents or cleaning agents. Any repairs or replacements should only be carried out by the service centre or an electrician. Have your device repaired at the service centre or by qualified specialist personnel using original manufacturer parts only. [. . . ]