User manual PARKSIDE PBS 600 A1 BELT SANDER

[. . . ] Always use a sanding belt and grade of grit suitable for the particular surface you are sanding. Any other use or modification to the device shall be considered as improper use and Introduction / General safety advice for electrical power tools General safety advice for electrical power tools wARNING!Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. Noise and vibration data: Measured values for noise are determined in accordance with EN 60745. [. . . ] Check for any parts that are broken or damaged enough to detrimentally affect the functioning of the device. Many accidents have their origins in poorly maintained electrical power tools. Carefully maintained cutting tools with sharp cutting edges are less likely to jam and are easier to control. In accordance with these instructions and advice, and the stipulations drawn up for this particular type of device. In doing this, take into account the working conditions and the task in hand. The use of electrical power tools for purposes other than those intended can lead to dangerous situations. That give rise to dusts that are hazardous to health, the sander must be connected to a suitable external dust extraction device. Ensure that there is adequate ventilation when working on plastic, paint, varnish etc. The belt sander is designed for the dry sanding of large surfaces of wood, plastic, metal and plaster and painted surfaces. Sanding paints containing lead, some types of wood and metal for example may give rise to hazardous or poisonous dusts and represents a risk to the health of the person operating the device and to anyone near the work area. Never support yourself by placing your hands near or in front of the device or the workpiece surface. If a dangerous situation arises, pull the mains plug immediately out of the mains socket. Always work with the mains lead leading away from the rear of the device. After sanding, lift the device from the workpiece before switching it off. When working always hold the device securely with both hands (see Fig. Switch the device off and allow it to come to a complete standstill before you put it down. When taking a break from your work, before carrying out any tasks on the device itself (e. Changing the sanding belt) and when you are not using the device, always pull the mains plug out of the mains socket. ½ Hold the device by the insulated handle surfaces as the sanding belt could strike the device's own mains lead. Damaging a live wire could result in the metal parts of the device also becoming live and could lead to an electric shock. For this reason, always make sure that nobody is placed in any danger and that there are no inflammable materials near the working area. ½ When undertaking prolonged sanding of wood, and in particular when working on materials Before you carry out any work on the belt sander always pull the plug out of the mains socket. [. . . ] The warranty period will not be extended by repairs made unter warranty. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Com In accordance with European Directive 2002 / 96 / EC (covering waste electrical and electronic equipment) and its transposition into national legislation, worn out electrical power tools must be collected separately and taken for environmentally compatible recycling. [. . . ]