User manual PARKSIDE PAHKS 18 V

[. . . ] When you are using the circular saw always wear ear protectors and protective glasses. Protective gloves, robust non-slip shoes, and a protective apron are also recommended. Every time before using the circular saw make sure that you check it for any damage. If any parts are damaged have them fixed or replaced at a specialist repair centre. [. . . ] 03. Protect the charger, battery pack and electrical equipment from moisture, e. g. 04. Always check before using the charging device that the mains has been connected properly. 05. The charging device must be switched off immediately if you discover any damage to the mains. 06. When you are not using the charger, remove the plug from the mains socket. Do not pull the plug with the mains connection. 5 www. kompernass. com +++ www. kompernass. com +++ www. kompernass. com +++ 07. If the tool is dropped or otherwise subjected to mechanical stress, you should have it examined by an appropriate specialist for damage before using it again. 10. Always remove the plug from the mains socket before you clean or maintain the charger or the battery pack. 11. Do not charge the battery pack if the ambient temperature is less than 10 ° C or greater than 40 ° C. This could lead to overheating or bursting of the storage battery pack. Any of these can cause damage to the battery pack or danger to the user. Therefore: · Do not connect a cable to the battery pack terminals. · Make sure that no metal objects (nails, paperclips, coins etc. ) find their way into the battery pack charging socket. 14. A damaged battery pack or one which no longer holds its charge must be disposed of specially and not placed in normal household rubbish. Insertion and removal of your battery pack Before removing the battery pack from the charger or inserting it into the charger, always ensure the plug is not in the mains socket. When attaching the battery pack, the groove in the battery pack must align with the guide on the cordless circular saw. Do not use any disproportionate force during insertion or the battery pack may not end up in its correct position. After the battery pack has been inserted check that the retaining clips have engaged and the battery pack is seated firmly in the charger. To remove the battery pack from the charger press the retaining clips on the sides of the battery pack and remove it. Charging the battery pack Before inserting the battery pack into the charger or removing it from the charger, always ensure the plug is not in the mains socket. The green charging light lets you know when charging is complete and the battery pack is ready for use. If you wish to charge a second battery pack, pull out the plug from the mains supply and keep the charger off for at least 15 minutes. [. . . ] If the circular saw is used continuously until the battery is completely discharged, then you should let the machine rest for 15 minutes before starting it again with a freshly charged battery. FITTING AND REMOVING SAW BLADES Before fitting or removing a saw blade always make sure that the circular saw is switched off and the battery pack is removed. Removing a saw blade: Press the spindle stop to prevent the saw blade from rotating. Fitting a saw blade: Carry out the steps detailed in "Removing a saw blade" in reverse order. When fitting the blade, make sure that it is mounted in the correct direction of rotation . SETTING THE GUIDE PLATE The default setting or the angle of the guide plate to the saw blade is 90°. [. . . ]