User manual PARKSIDE PABS 10.8 A2

[. . . ] Failure to observe the safety advice and instructions may result in electric shock, fire and / or serious injury. Keep all the safety advice and instructions in a safe place for future reference!The term "electrical tool" used in the safety advice refers to electrical tools powered by mains electricity (by means of a mains lead) and electrical tools powered by rechargeable batteries (without a mains lead). Noise / vibration data: Measured values for noise are determined in accordance with EN 60745. [. . . ] Loose clothing, jewellery or long hair can become trapped in moving parts. If vacuum dust extraction and collection devices are fitted do not forget to check that they are properly connected and correctly used. Careful handling and use of electrical power tools a) Do not overload the device. Always use an electrical power tool that is intended for the task you are undertaking. By using the right electrical power tool for the job you will work more safely and achieve a better result. A) Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of drugs, alcohol or medication. One moment of carelessness when using the device can lead to serious injury. General safety advice for electrical power tools Tool that can no longer be switched on and off is dangerous and must be repaired. Pull the mains plug out of the socket and / or remove the rechargeable battery before you make any adjustments to the device, change accessories or when the device is put away. This precaution is intended to prevent the device from unintentionally starting. General safety advice for electrical power tools / Before first use wARNING!The inserted tool may strike concealed electricity cables, therefore when working you must hold the electrical power tool by the insulated handle areas only. Contact with a live wire means that the metal parts of the electrical power tools may become live and this can result in an electric shock. Before you carry out any tasks on the device, transport or store it, make sure that the direction of rotation switch is in the middle position (lock). Children or persons who lack the knowledge or experience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or instruction by a person responsible for their safety. Before first use Removing / charging / inserting rechargeable battery pack Charge the battery in the charging station for at least three hours before first use. You can charge the Li-Ion battery at any time without risk of shortening battery life. In order to remove the rechargeable battery pack 8 , press the release buttons 9 and take the rechargeable battery pack 8 out of the device. The green charge indicator LED 15 shows you that the charging process is complete and the battery pack 8 is ready for use. Take steps to ensure that you do not hit upon any service lines (electricity, gas, water) when working with electrical appliances. Check, if need be with a service line detector, before you start to cut or bore into a surface. [. . . ] Hard screw bed: Particularly high torques can occur, for example with metal screws tightened by socket tool bits. Soft screw bed: You should also select a low speed in order not to damage the wood workpiece surface through contact with the metal screw head. When drilling into wood, metal and other materials: With small diameter drill bits use a high drill speed. Mark the intended position of the hole with a centre punch or a nail and select a low drill speed for drilling. [. . . ]